GXV140N Honda - Overview

This is an authentic Honda replacement part, sourced from the original manufacturer for use with small engines. The special hex head bolt is commonly used to secure the ignition module assembly. This flanged bolt is available as an individual replacement part, please see illustrated part list for associative parts.

This is an authentic manufacturer sourced replacement part designed for use with Honda engines. This carburetor gasket provides an air tight seal between the carburetor and the insulator. Over time gaskets tend to deteriorate and would need to be replaced. It is made out of compound material and it is sold individually. You would need a screwdriver to replace this item.

This is an authentic Honda replacement part. This part is used in Honda engines. It consists of a high-quality plastic frame with pleated fabric filter, and is used to remove dust and debris as the engine runs. Please be aware that there may be more than one model of air cleaner. Use the parts diagram to be sure you order the right pa...Read morert for your engine model. You will require a screwdriver to replace this item. This is a common wear part. We recommend ordering a spare.

This is an original part from Honda that is used in a small engine. The key sits in the keyway and keeps the flywheel from free spinning when turned. This part is half mooned shaped and is made of metal. This part is sold as an individual replacement part.

This is an authentic manufacturer-sourced component which is designed for use with Honda engines that are commonly installed on a variety of lawn and garden equipment. It is an identical replacement for a damaged or a missing clutch cam that was installed on a new unit. Over time the material will wear out and it may begin to crack eventu...Read moreally requiring a replacement. It is made of high-quality rubber and is sold individually.

The carburetor spacer goes between the carburetor insulator and the carburetor. It is a genuine item that is supplied by the original equipment manufacturer for use with Honda small engines and Toro lawn mowers. This part is made of metal and is sold individually. If this item becomes broken it will need to be replaced and may require a screwdriver during the installation.

The flange bolt is used to secure parts together in a variety of lawn and garden outdoor equipment. It is sourced directly from the manufacturer and has a diameter of 6mm and a length of 12mm. The bolt is made of metal and has a ring-shaped rim on one end known as a flange. This flange helps to secure the bolt in place and prevents it fro...Read morem falling off during use. Inspect all the bolts on your equipment as you may need more than one. If you note that any of them are deformed, corroded or the threads are worn down, you will need to replace them as each bolt is sold individually. Remove the damaged bolt and thread the new one on with your hands before tightening with a wrench.

This part is an OEM from the Honda manufacturer. The valve rocker arm is made for use with many small engines. This metal component is designed to open and close the valve. Over time it may wear out or get damaged eventually requiring a replacement. The valve rocker arm is sold individually. Please be sure to refer to the specific manual ...Read morefor repair instructions. When replacing the valve rocker arm, a wrench set is necessary.

This is an authentic Honda replacement part. This outer filter is used with small engines that are commonly installed on a variety of lawn and garden equipment. It is made of high-quality foam material and is used to remove dust and debris as the engine runs. Over time it may wear out and get clogged eventually requiring a replacement. No...Read morete, this part is sold individually. Refer to the owner's manual for the correct application.

This is a genuine manufacturer-approved component which is designed for Honda engines that are commonly installed on a variety of lawn and garden equipment. It is an identical replacement for a missing or a damaged oil seal that was installed on a new unit. Refer to the owners manual and the parts diagram for your model to ensure the corr...Read moreect replacement procedure. Note, this high-quality oil seal is made of a durable material and is sold as an individual item. A screwdriver and a wrench set will be needed to perform this repair.