GWS1749CS0 Gibson Washer - Parts

The capacitor is used on the washer motor to help the motor get up to speed quickly before transferring power to the run capacitor.

This is the bolt (screw) that holds the agitator in place.

This water inlet hose is used in washers. The hose connects the washer water inlet valve to the water supply in your home. There are two solenoids on the valve, which are referred to as coils, and there are two wires attached to each solenoid that should be labelled to ensure they are properly reconnected after replacing the new hose. Ove...Read morer time, your hose can begin to leak which can lead to floods. Replacing your hose earlier on can prevent this problem. Refer to the diagram provided by the manufacturer for installation instructions. Remember to unplug your appliance from the power source before beginning this installation project.

Use in conjunction with the agitator screw.

Sold Individually. Pan Head Screw - 8-18ab X 0.375

This clip is less than an inch long.

The tub ring seal or splash cover seal is used for washers. This part seals the tub cover to the outer one and prevents water leakage from around the tub ring. If your seal is damaged and you are experiencing water leakage, it is best to replace this part. Refer to the manual provided by the manufacturer for further installation instructi...Read moreons. Remember to unplug your washer from the power source before starting this installation process.

This part helps with the spinning and agitating cycles.

Appliance requires 2. Sold Individually. They are located on top of the service panel to be able to attach it to the main frame of the washer.

This part goes on top of the agitator.