All Installation Instructions for LG Refrigerator GM-L277UTRY

The ice tray had warped and dumped water, which then froze down through the ice bucket and below.

8 of 8 people found this instruction helpful.

George from ATLANTA, GA
Easy
Less than 15 mins
Screw drivers

To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting.
Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards.
The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and ... Read more

Read less

Was this helpful?

Replace Gasket on refrigerator door

6 of 10 people found this instruction helpful.

Curtis from DEMOPOLIS, AL
A Bit Difficult
30 - 60 mins
Screw drivers

The replacement gasket does not have as strong a magnet as the original one. I removed the old one carefully so as not to cause more damage in case I have to put it back. Using Tongue suppressor I pushed new gasket into place and put a thin coating of protelem jelly on the gasket. I just have to make sure the door is closed each time to ... Read more

Read less

Was this helpful?

gaskets worn out again

1 of 2 people found this instruction helpful.

Keith from Phoenix, AZ
Really Easy
Less than 15 mins

replaced gaskets for the second time in four years

Other Parts Used:

Gasket Assembly,Door

Was this helpful?

Ice tray was bent and spilling water onto ice making it freeze

William from Nolensville, TN
Really Easy
15 - 30 mins
Screw drivers

I took the ice out with one screw and took out the old tray the new one slipped right in and I hooked up the little heat strip with one snap works perfect cost $10 I was told by appliance repair tech that I needed to replace the ice maker for $450 saved $440 dollars replacing the bent or warped ice tray

Was this helpful?

GM-L277UTRY LG Refrigerator - Instructions