GLEFS79DBB Frigidaire Range - Parts

Handle only.

The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, or stove from tipping when force or weight is applied to an open oven door. The bracket is secured to the floor and wall and fits over the rear leveling leg in ...Read morethe back of the appliance, in a cutout specifically designed for the anti-tip bracket. This part is very essential to the safe operation of the appliance. Failure to install the bracket properly can result in the oven tipping or falling and causing injuries.

Sold Individually. These legs should be adjusted to make your appliance level on uneven flooring.

This is a genuine oven rack, which works with ranges.

This steel washer is also known as the range washer and is used on your oven door. The measurements for the steel washer are a three quarter inch outer diameter, and a one quarter inch inner diameter. This washer is an OEM part, made of steel, which is sourced directly from the manufacturer. This specific steel washer is used with your ra...Read morenge, to secure the inner and outer door together and to secure the oven door handle back in place. Users have ranked this repair as a simple installation that should take you less than fifteen minutes to complete.

This is the part the handle screws into for installation.

The oven light socket allows you to screw in a light bulb so that you can see the inside of your oven. The light socket is located in the back of your oven, so you will need to remove the back panel to access the socket for the repair. You will also need to remove the current light bulb and the light lens cover so that the old socket can ...Read morebe removed. As you will be working around electrical circuits for this repair, be sure to disconnect the power source from the oven before you begin work on the oven.

Sold Individually.

This surface burner knob is used in ranges and ovens. The knob allows you to control the temperature on the surface burner located on the range. It has a D-shaped shaft and the measurements are: 4 inches in length, 5 inches in width, 1 inch in height, and it weighs 0.01 pounds. It comes in a black color with a white pointer. If your knob ...Read moreis broken, will not turn on or off, or it does not rotate, replacing this part can be the solution to your problem. Remember to unplug your range from the power source before beginning this project. Refer to the manual provided by the manufacturer for further installation instructions.

This part is sold individually. The leveling leg is black in color and measures approximately 2 inches in length. It is made of plastic. The leveling leg is found underneath your range and may crack or wear down over time. This will need to be replaced if it has broken or gone missing. If you notice your oven is wobbling or uneven it may ...Read morebe due to the leveling leg needing to be replaced. This part can be adjusted to accommodate different heights due to uneven flooring. This is a genuine OEM part sourced directly from the manufacturer.

This is just the outer glass panel of the door. The tape is not included with this part. Must order tape separately.