GC160WME2 Honda Engine - Parts

This carburetor is for lawn and garden equipment engines. Carburetor mixes air and gas before the fuel mix goes to the engine. Wear work gloves to protect your hands and work in a well-ventilated area during this repair.

This genuine Honda flange nut is generally used to secure fan or starter housing to the main unit. It is an authentic item sourced from original equipment manufacturer for use with small engines. It is a hex flange nut which would require a wrench fro installation. Please note this item is sold individually.

It is an authentic replacement o-ring that is supplied by original equipment manufacturer for use with Honda engines. This is the item that creates a seal between the camshaft pulley and the shaft, for correct application please make sure to check appropriate diagrams of your model. Over time the material may deteriorate and crack allowin...Read moreg for leaks, if this happens the o-ring will need to be replaced. Please note this durable rubber item is sold individually.

The oil seal attaches to the cylinder assembly. This is an authentic Honda and Toro replacement part used in compatible small engines. This item is available as an individual replacement part. It is made of metal and rubber and will require replacing if it breaks. A screwdriver and a set of pliers may be required during the replacement of this part.

Honda engine oil, SAE 10W-30, One quart

This spring-throttle return is an OEM part. It is designed for Honda engines that are commonly installed on a variety of lawn and garden equipment. It applies tension on the governor rod allowing it to retract. The governor system is like a cruise control system. It maintains the speed by adjusting the carburetor. Over time it may wear ou...Read moret and stretch eventually requiring a replacement. One durable metal spring is included. Refer to the diagrams for your model for the exact location and the correct installation of this hardware. It is best to use pliers to remove the old one and secure the new one.

This replacement recoil starter assembly is commonly used with small Honda engines. This is the starter assembly that is used to pull start the unit. It is a complete assembly that includes a plastic shroud/housing, starter pulley, starter spring, grip and the pull rope. Please note the hardware/screws to attach this assembly are sold sep...Read morearately. Replacing this starter assembly is a simple task that should only require a screwdriver. • Make sure to disconnect the spark plug • Remove housing screws • Separate the old housing from the unit • Secure the new housing with the screws • Reattach spark plug and test the equipment

A genuine OEM sourced replacement component which is specially designed for use with Honda engines commonly installed on lawn and garden equipment. This is the grip that attaches the starter rope that starts the engine. To attach the starter rope to the grip, push the rope thru the bottom hole in the grip, then bring it out the other side and tie a knot. Please note this durable plastic item is sold individually.

This bolt helps to secure muffler and carburetor to the short block. It is sourced from original equipment manufacturer for use with Honda small engines. Usually this bolt would need replacement if it is lost or has stripped threads. Please note this is a hex head bolt requiring a wrench for installation. It is sold individually.

This is an original part from Honda that is used in a small engine. The key sits in the keyway and keeps the flywheel from free spinning when turned. This part is half mooned shaped and is made of metal. This part is sold as an individual replacement part.