This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as ...Read morethey commonly wear at the same rate. This is about 1 inch long and metallic in color.
This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.
This water inlet valve is a genuine replacement component designed to regulate the flow of water to both the ice maker and water dispenser in select refrigerator models. It ensures a steady and controlled supply of water, supporting consistent ice production and reliable dispensing. If the valve is faulty, symptoms may include no ice prod...Read moreuction, a non-functioning water dispenser, water leaks near the valve, or unusual noises during operation. Replacing the valve can restore proper performance and improve overall efficiency. Installation should be performed with the appliance unplugged or the water supply turned off. Always verify compatibility with your specific model before installation.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
replace leaking water inlet valve assembly
42 of 75 peoplefound this instruction helpful.
Richard from JACKSONVILLE, FL
Really Easy
15 - 30 mins
Screw drivers
1. Shut off water to refrigerator. 2. Removed bottom sheet metal cover (6 screws). 3. Removed leaking water inlet valve assembly from refrigerator (1 screw). 4. Remove water inlet tube (loosen nut) and tube back to refrigerator (pull from water valve after remove cotter pin washer). 5. Detach two electrical wire harnesses. 6. Install new
... Read morewater inlet valve assembly to refrigerator (1 screw). 7. Replace both water tubes to water inlet assembly. 8. Re-attach both wiring harnesses. 9. Turn water to refrigerator on. 10. Check for leaks. 11. Re-attach bottom sheet cover (6 screws).
Read less
Was this helpful?
Thank you for voting!
Low water pressure which in turn led to no water and no ice.
7 of 16 peoplefound this instruction helpful.
Daniel from ABERDEEN, WA
Really Easy
30 - 60 mins
Nutdriver, Screw drivers, Wrench set
Unplugged fridge, shut off water supply disconnected water supply from fridge. Remove screws that hold lower cover on back of fridge, removed screws holding valve assembly to fridge. Disconnect two electrical connections, remove black c-clip on out flow water line, lift fitting on outflow line side and pull water line off. Replace with va
... Read morelve assembly in reverse order
Read less
Was this helpful?
Thank you for voting!
Leaking
2 of 3 peoplefound this instruction helpful.
Johnny from MOUNT OLIVE, AL
Really Easy
30 - 60 mins
Screw drivers
Swapped old one with new one. New one had extra plug not needed.