FX730V-CS21 Kawasaki Engine - Parts

This metal plate, is an authentic manufacturer replacement part used in outdoor power equipment as a part of the governor assembly. It is one of the two plates attached to the end of the camshaft which plays a key role in regulating the engine speed. When the engine speed increases or decreases, the plates are forced outward or inward, th...Read moreereby actuating the throttle and controlling the amount of air and fuel that enters the engine. This process allows the engine to maintain a consistent speed. If the plates become damaged or dislodged, you will notice fluctuating engine speed and poor load response. Before removing the plates, first disconnect the springs and linkage attached to them. Detach the plates from the camshaft and position the new ones in place.

This is an authentic Kawasaki replacement part that has been sourced from the original manufacturer to be used four stroke engines. The filter is used to prevent dirt and debris from entering the engine's air intake. It is recommended to periodically replace the air filter to maintain the engine's performance. This item is sold as an individual replacement part.

This governor plate, also known as the governor control, is supplied by the original manufacturer for use in a variety of outdoor power equipment. It is a metal plate that works with the throttle linkage to allow the engine to maintain a consistent speed during operation. If the governor plate wears down or becomes damaged, you will notic...Read moree that the engine will stall under load, and the revolutions per minute (RPM) in your equipment will fluctuate, causing over-speeding or under-speeding as well as inconsistent power output, and performance. Therefore, it is critical to replace this part if it is no longer working, in order to continue operating your equipment. You can find the governor plate near the throttle linkage assembly in your equipment engine. Depending on your model, you may need to remove the air filter housing to access the plate. Disconnect the throttle linkage from the governor plate and remove the faulty governor plate. Place the new one in position, secure it with the appropriate fasteners, and reverse-assemble the rest of the engine components to complete your repair.

It is a genuine OEM sourced part that is specially designed for use with Kawasaki engines commonly installed on lawn and garden equipment. This item fits the opening in the crankcase helps to provide an air-tight seal to prevent any leaks. Over time seals tend to get compressed and may begin to crack eventually requiring replacements. It ...Read moreis made of durable rubber material and is sold individually. Refer to the appropriate diagrams for your model to ensure the correct repair procedure.

This is an original Kawasaki replacement part. The connecting rod assembly is commonly found in small engines. This part is made of metal, and is connected to the crankshaft and piston, allowing the motion of the crankshaft to move the piston. You may require a wrench when replacing this part. This item is sold individually.

This replacement gasket is an authentic manufacturer sourced item that is specially designed for Kawasaki engines. This item provides an air tight seal for the rocker case, over time gaskets tend to deteriorate and get compresses eventually requiring replacement. One durable composite material gasket is sold individually, to replace it you will need a wrench.

This is an authentic Kawasaki replacement part. The air filter element is designed by the manufacturer for use in engines. This part is a plastic and metal casing with the filter material inside, and it is used to remove dust and debris from the air as it passes through the machine. You may require a wrench when replacing this part. This item is sold individually.

This is an original Kawasaki replacement part manufactured for use with four stroke engines. The special gasket is commonly used to seal the connection between the intake pipe and the cylinder. It is recommended to replace gaskets when servicing the engine to ensure proper seals when the parts are reassembled. This gasket is available as an individual replacement part.

The valve spring retainer goes between the spring and the collet. This part is made of metal and is available individually. It is an OEM from Kawasaki, Toro, and Lawn Boy for use in engines. A screwdriver, a socket set, and a wrench set might be helpful during the installation of this part. This item will need to be replaced if it breaks.