- Home
- FV05M2WSFC
- Instructions
FV05M2WSFC Frigidaire Freezer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
broken shelf end
0 of 1 people
found this instruction helpful.
-
Roger from Enfield, NH
- Really Easy
- Less than 15 mins
snapped in the new shelf end and we were back in business. Thanks for the great & fast service RJL
Was this helpful?
Thank you for voting!
The refrgerator would not run
3 of 10 people
found this instruction helpful.
-
Alan from Puyallup, WA
- Easy
- 15 - 30 mins
-
Screw drivers
When I pulled the compressor relay out to check it, it disintegrated in my hands. Replced relay for $4.14.
Was this helpful?
Thank you for voting!
Evaporator freezing up. Noticed Ice cream not frozen solid
0 of 1 people
found this instruction helpful.
-
Paul from Buffalo, MN
- Really Easy
- 30 - 60 mins
-
Screw drivers
Notice ice build up on the panel in front of the evaporator coil. Unplugged freezer and removed evaporator panel. Plugged unit back in and checked fan, coil "snap switch" and heater element, all seemed to check out good. Found defrost timer stuck in the freeze position, causing frost to accumulate over the evaporator. Manually rotated
... Read more
defrost timer to the 30min defrost cycle and system went into defrost. Ordered defrost timer and installed (part arrived in 3 days). Freezer works great again. Too bad I ended up throwing 400 dollars worth of meat away. the fix was very simple. Will definitely use PartSelect again. Thank you.
Read less
Was this helpful?
Thank you for voting!
Broken door shelf end brackets
0 of 3 people
found this instruction helpful.
-
RUDOLPH from PRINCETON, TX
- Really Easy
- Less than 15 mins
Push-in replacement - easy. I must note that I received my order within two days - remarkable service from Part Select!
Was this helpful?
Thank you for voting!
Broken door end cap.
0 of 5 people
found this instruction helpful.
-
Duane from Merrill, MI
- Really Easy
- Less than 15 mins
I was so supprised that Part slect was around and had the part . You can count on me to tell others about your wonderful service . I will see to it that I use your service when somthing else goes wrong with any of my appliences
Thanks again !
Thanks again !
Was this helpful?
Thank you for voting!
door shelf useless
0 of 9 people
found this instruction helpful.
-
Joel from Spring Green, WI
- Easy
- Less than 15 mins
Decide how to snap end cap into door.
Put one end on door.
Fasten bar, then with other end cap
in the bar, snap it into the door.
Put one end on door.
Fasten bar, then with other end cap
in the bar, snap it into the door.
Was this helpful?
Thank you for voting!
Coils not Defrosting and stopped freezing
-
Joseph from Yulee, FL
- Really Easy
- 15 - 30 mins
-
Screw drivers
Upluged power pulled freezer out from wall removed the two screws that holds the defrost timer unpluged defrost timer pluged new timer in mounted new timer back with the two screws pluged freezer back in and job was complete. Freezer working fine.
Was this helpful?
Thank you for voting!
Refrig unit was frosting up top and bottom, did not properly defrost and stop cooling especially in lower compartment.
-
BILL from GENOA, WV
- Really Easy
- 15 - 30 mins
-
Nutdriver
Unplug the refrigerator unit from wall. I removed freezer rack, plastic light cover, the ice rack shelf on the right side, then removed the plastic back cover panel, (4) retaining screws, gently tilting the panel toward me, unplug the wiring harness by depressing the clips on the side of the plug, removed panel from unit, set aside. If th
... Read more
e unit was froze up, so I defrosted the cooling coils carefully with a common hair dryer until it was thawed. Be careful not to touch or bend the coils , since they are very fragile and SHARP! I located the old thermostat unit attached to a straight length of coolant line. The new unit looked like the old one, so it was easy to locate. I cut the two wires of the old unit close to the round base to make sure I would have enough wire to reconnect. Since my new unit did not indicate a polarity(Neg or Pos), I just wired each wire I cut to one of the new unit. I used the shrink tubing provided and heated the shrink till it was fully melted. I double ck'd to see if the wires were basically waterproof and a good connect. Also, before I replaced the rear panel, I made sure that both wires I had spliced had a drip loop to it so water would not drip down into the newly spliced union. Also made sure the wires will not interfere with the colling fan on the back of the rear panel. Reverse the procedure in reassembling. Plug in unit, and wait and listen for the unit coming back on..I kept a regular thermometer in the upper and lower compartments. Allow 24 hrs. for the unit to return to normal operation. It may defrost several times till the whole operation is back in sync.
Read less
Was this helpful?
Thank you for voting!
the freezer coils were not defrosting so they would ice up and cut off the cold air into the refrigerator side
-
mark from murrieta, CA
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers
there were three possible problems the timer, the thermostat, or the heating element.i replaced the timer first as that is the problem 65% of the time and that did not fix the problem, i replaced the thermostat and that did fix the problem. after watching the video on line from parts select i took the back off of the freezer from the insi
... Read more
de, defrosted the coils with a hair blower and then swapped out the thermostat which pops right off and i spliced the old connectors to the new thermostat. the heat shrink tubing that came with the part was a little to big so i put a smaller peice on each side for water proofing. that is what the cigarette lighter is for to supply heat to the heat shrink tubing.now that i have fixed that problem i may tackle the ice maker next
Read less
Was this helpful?
Thank you for voting!
Needed a freezer key
-
Nancy from Star Lake, NY
- Really Easy
- Less than 15 mins
We really didn t need to do a repair, we just ordered a freezer key that we didn t have. I must say the shipping was fast we received it the next day. It was worth the shipping charge. We will be ordering again. Great service.
Was this helpful?
Thank you for voting!
freezer door got locked and we couldn't find the key
-
Linda from Fresno, CA
- Really Easy
- Less than 15 mins
inserted key and turned
Was this helpful?
Thank you for voting!
Broken shelf end cap
-
Donn from Saint PAUL, MN
- Really Easy
- Less than 15 mins
Truly a 10-second fix.
Was this helpful?
Thank you for voting!
lost key
-
Stephen from noble, OK
- Really Easy
- Less than 15 mins
Ordered freezer key friday afternoon received it saturday afternoon. Fast service
Was this helpful?
Thank you for voting!
The tabs on the shelf end broke off.
-
Edwin from Littleton, CO
- Easy
- Less than 15 mins
Removed the broken shelf ends and installed the new ones. Then installed the assembly on the freezer door. Trick was to put the long end of the tab in first followed by the short end. The up end was reversed on the opposite shelf end.
Was this helpful?
Thank you for voting!
Freezer was warm
-
Charles from Macomb, MI
- Really Easy
- 30 - 60 mins
-
Screw drivers
I first noticed my ice cream getting soft. Then 2 days later the alarm went. I emptied the freezer, opened the panels and saw no frost. I saw that 99% of issues were resolved with a defrost timer and thermostat so I ordered those. I have to say the parts came quickly and they went in very easy. My freezer seems to be in the 1% categor
... Read more
y though. It's still not cooling even though I can measure the temperature at the front of the evaporator coil is cold but by the end of the coil it's almost room temperature. I think a repairman is called for.
Read less
Was this helpful?
Thank you for voting!