FS651V-ES10 Kawasaki Engine - Parts

It is a genuine OEM sourced part that is specially designed for use with Kawasaki engines commonly installed on lawn and garden equipment. This item fits the opening in the crankcase helps to provide an air-tight seal to prevent any leaks. Over time seals tend to get compressed and may begin to crack eventually requiring replacements. It ...Read moreis made of durable rubber material and is sold individually. Refer to the appropriate diagrams for your model to ensure the correct repair procedure.

This is an original Kawasaki replacement part. The connecting rod assembly is commonly found in small engines. This part is made of metal, and is connected to the crankshaft and piston, allowing the motion of the crankshaft to move the piston. You may require a wrench when replacing this part. This item is sold individually.

The valve spring retainer goes between the spring and the collet. This part is made of metal and is available individually. It is an OEM from Kawasaki, Toro, and Lawn Boy for use in engines. A screwdriver, a socket set, and a wrench set might be helpful during the installation of this part. This item will need to be replaced if it breaks.

This is an authentic Kawasaki replacement part, sourced from the original manufacturer for use with small engines. The insulator is used to provide spacing between the intake manifold assembly and the carburetor. This insulator is sold as an individual replacement part, please note the gaskets are available separately.

This flanged bolt is a genuine OEM steel fastener used to secure various components in outdoor power equipment. It features a flange base that acts as a built-in washer to distribute the load and prevent damage to the material it is fastened to. The bolt head has a diameter of 6mm, and the bolt shaft has a thread pitch of 20. The bolt can...Read more corrode and crack over time, or its threads may wear down, leading to loosening or detachment of the connected parts. You will likely note excessive noise, vibrations, and equipment instability. Inspect all the bolts in your equipment and replace those that are no longer functioning. Use a wrench or socket to loosen and remove the old bolt. Position the new bolt on the mounting surface and tighten it securely until the flange is flush against the surface. Each flanged bolt is sold individually.

This authentic manufacturer-supplied component is made for Kawasaki engines that are commonly installed on lawn and garden equipment. The spring applies tension on the valve allowing it to retract. Over time it will wear out and it may begin to stretch eventually requiring a replacement. This high-quality spring is made of durable metal a...Read morend is sold as an individual item. Check the diagrams for your model to ensure the proper repair procedure. A screwdriver will be needed to replace this hardware.