FP200300AV Campbell Hausfeld Compressor - Parts

This is a genuine manufacturer sourced replacement regulator. It is specially designed for Campbell Hausfeld air compressors. This part adjusts the pressure of the air coming from the tank to the desired level. Please note, this only includes the metal regulator and the plastic knob. The valves, gauges and the pressure switch are all sold...Read more separately. To complete this repair you would need an a screwdriver, pliers and a set of wrenches. • First make sure to unplug the compressor • Drain the air from the tank • Disconnect all the valves and gauges from the regulator • Remove the old regulator • Secure the new regulator assembly • Reassemble and test the new regulator

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

This genuine OEM replacement nipple is designed for use in air compressors, serving as a critical connector between the pressure switch, the tank, and the regulator. A damaged or corroded nipple can lead to air leaks and inconsistent pressure, affecting overall performance. To check for leaks, apply soapy water to the fittings around the ...Read morepressure switch and watch for bubbles. If replacement is necessary, the process typically involves disassembling the pressure switch. Begin by draining the tank using the valve at the bottom, then remove the coupler from the regulator and unthread the nipple. Access the wire connections by removing the pressure switch shroud, and carefully note the position of each wire before disconnecting them—starting with the motor wire, followed by the cord wires and ground wires. Remove the strain relief, pressure gauge, and the airline connecting the check valve to the switch. Finally, unthread the pressure switch from the tank nipple and remove the nipple itself. When reassembling, it is recommended to use thread tape to ensure a proper seal. This replacement part is sold individually.

This genuine replacement on/off switch is specially designed for Campbell Hausfeld air compressors. It is supplied directly from original manufacturer and it is sold individually. This switch is used to turn the compressor on and off. Switches have moving mechanical parts that will eventually fail. At this point the switch should be repla...Read moreced. This is a simple repair that will only require a screwdriver. • Remove screws from the housing • Lift up the housing • Disconnect wires from the switch • Remove old switch and secure new one in place • Reassemble and test the compressor

This item is available as an individual replacement part. The gauge attaches to the manifold and is made of metal and plastic. It will require replacing if it stops working. During replacement, it may require a wrench set to help install this part correctly. This genuine item is supplied by the original equipment manufacturer for use with Campbell Hausfeld oilless compressors.

This is an OEM part sourced directly from the manufacturer. The safety valve is designed for use in Campbell Hausfeld compressors. This part is made of metal, and is connected to the tank to release excess air when the pressure becomes too high. You may require a wrench when replacing this part. This item is sold individually.