FH641V (GS06) Kawasaki Engine - Parts

This is an authentic Kawasaki replacement part, sourced from the original manufacturer for use with small engines. The special clamp is commonly used to secure the engines breather tube assembly. This clamp is available as an individual replacement part, please note pliers may be required to install the clamp.

This is a special item that provides a tight fit between connected parts. Over time it may wear out, get damaged or lost eventually requiring a replacement. Check the appropriate diagrams for your model to ensure the proper repair procedure. This high-quality spacer is made of durable material and is sold as an individual item. It is a ge...Read morenuine manufacturer-supplied item that is made for Kawasaki engines that are commonly installed on a variety of lawn and garden equipment.

This special item is utilized to provide a tight seal between connected components. Unfortunately, over time the material will wear out and it may begin to crack eventually requiring a replacement. Keep in mind this high-quality part is made of durable rubber material and is sold as an individual item. It is a genuine item that is supplied by the original equipment manufacturer for use on lawn and garden equipment.

This authentic manufacturer-sourced component is specially designed for Kawasaki engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or a damaged bolt-stud that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and app...Read morelication of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This is a genuine OEM sourced component which is specially designed for use with Kawasaki engines commonly installed on lawn and garden equipment. The ignition module also known as armature-magneto provides the current for the ignition system by producing pulses of high voltage for the spark plugs. It is made out of high-quality materials...Read more and is sold as an individual assembly. Note, it includes an attached spark plug boot. To complete this repair you would need screwdriver set. Please note replacing this module would differ based on your unit, however, the basic steps would be the same. • Remove the housing/covers from the unit • Remove the spark plug • Bind the cylinder • Remove the air filter cover and side cover • Remove the throttle cable from the carburetor • Disconnect the wires • Remove old ignition coil • Install new ignition coil • Install the red wire • Set the gap • Install the black wire • Reassemble and test the unit