FH601V (FS21) Kawasaki Engine - Parts

This metal plate, is an authentic manufacturer replacement part used in outdoor power equipment as a part of the governor assembly. It is one of the two plates attached to the end of the camshaft which plays a key role in regulating the engine speed. When the engine speed increases or decreases, the plates are forced outward or inward, th...Read moreereby actuating the throttle and controlling the amount of air and fuel that enters the engine. This process allows the engine to maintain a consistent speed. If the plates become damaged or dislodged, you will notice fluctuating engine speed and poor load response. Before removing the plates, first disconnect the springs and linkage attached to them. Detach the plates from the camshaft and position the new ones in place.

This governor plate, also known as the governor control, is supplied by the original manufacturer for use in a variety of outdoor power equipment. It is a metal plate that works with the throttle linkage to allow the engine to maintain a consistent speed during operation. If the governor plate wears down or becomes damaged, you will notic...Read moree that the engine will stall under load, and the revolutions per minute (RPM) in your equipment will fluctuate, causing over-speeding or under-speeding as well as inconsistent power output, and performance. Therefore, it is critical to replace this part if it is no longer working, in order to continue operating your equipment. You can find the governor plate near the throttle linkage assembly in your equipment engine. Depending on your model, you may need to remove the air filter housing to access the plate. Disconnect the throttle linkage from the governor plate and remove the faulty governor plate. Place the new one in position, secure it with the appropriate fasteners, and reverse-assemble the rest of the engine components to complete your repair.

This is an authentic Kawasaki replacement part that has been sourced from the original manufacturer to be used with small engines. The cylinder head is used to cover the end of the cylinder and to provide a surface to allow the piston to compress the cylinder's contents. This item is available as an individual replacement part.

This bolt is generally used to secure muffler on engines. It is supplied from original equipment manufacturer for use with Kawasaki gas powered engines. This bolt has a hex head which requires a wrench for installation. Please note it is sold individually.

The valve spring retainer goes between the spring and the collet. This part is made of metal and is available individually. It is an OEM from Kawasaki, Toro, and Lawn Boy for use in engines. A screwdriver, a socket set, and a wrench set might be helpful during the installation of this part. This item will need to be replaced if it breaks.

This is an authentic Kawasaki replacement part manufactured for use with small engines. The float valve is used to prevent fuel from entering the float bowl when it is full, then allows fuel into the bowl when the fuel is drained from the float bowl. This float valve is sold as an individual replacement part, please see model diagram for associative parts.