- Home
- FFU12M4AW4
- Instructions
FFU12M4AW4 Frigidaire Freezer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer wasn't cooling - compressor not engaging
2 of 2 people
found this instruction helpful.
-
Judy from ROYSE CITY, TX
- Really Easy
- 30 - 60 mins
Ordered the Capacitor and the Thermostat Control. Parts were received in a matter of a few days, easy to install, but did not fix the problem. Had to call a repairman to fix the problem (compressor relay - this part not available to order for this model number with Parts Select). Will continue to use Parts Select in the future for other p
... Read more
arts, but not happy that the actual part I needed was not available - had to use other methods.
Read less
Was this helpful?
Thank you for voting!
No instructions included
1 person
found this instruction helpful.
-
Beverly from Provo, UT
- Easy
- Less than 15 mins
Visual assessment and put in by hand.
Was this helpful?
Thank you for voting!
The end cap of the bottom shelf of my freezer was broken
1 person
found this instruction helpful.
-
Kathleen from SELDEN, NY
- Really Easy
- Less than 15 mins
-
Screw drivers
Finally after a few years of putting the shelf back on and balancing food on it I looked up the part.
The clips came in a few days.
I used a screwdriver to pop off the old piece. I lined up the clip and pushed it in.!
I am sooo glad I purchased this.
The clips came in a few days.
I used a screwdriver to pop off the old piece. I lined up the clip and pushed it in.!
I am sooo glad I purchased this.
Was this helpful?
Thank you for voting!
Fridge quit working.
1 person
found this instruction helpful.
-
Bill from Bay City, MI
- Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers, Wrench set
A little research told me the hum plus no cooling was either the compressor or the relay. I ordered the new relay and put it in but it didn't fix the problem. I ended up having to buy a new fridge, but it was worth the $30 gamble to see if I could fix it on the cheap and it saved me the money a service call would've cost. Pretty easy i
... Read more
nstallation, just in a tight space on my model.
Read less
Was this helpful?
Thank you for voting!
broken pieces
2 of 5 people
found this instruction helpful.
-
D from Fairport, NY
- Really Easy
- Less than 15 mins
replaced them
Was this helpful?
Thank you for voting!
broken shelf end
0 of 1 people
found this instruction helpful.
-
Roger from Enfield, NH
- Really Easy
- Less than 15 mins
snapped in the new shelf end and we were back in business. Thanks for the great & fast service RJL
Was this helpful?
Thank you for voting!
Broken door shelf end brackets
0 of 3 people
found this instruction helpful.
-
RUDOLPH from PRINCETON, TX
- Really Easy
- Less than 15 mins
Push-in replacement - easy. I must note that I received my order within two days - remarkable service from Part Select!
Was this helpful?
Thank you for voting!
Broken door end cap.
0 of 5 people
found this instruction helpful.
-
Duane from Merrill, MI
- Really Easy
- Less than 15 mins
I was so supprised that Part slect was around and had the part . You can count on me to tell others about your wonderful service . I will see to it that I use your service when somthing else goes wrong with any of my appliences
Thanks again !
Thanks again !
Was this helpful?
Thank you for voting!
Plastic shelf supports broken
6 of 24 people
found this instruction helpful.
-
shari from west sand lake, NY
- Easy
- 15 - 30 mins
-
Pliers
Needed to remove both left and right broken (plastic) supports and reinsert the new parts. Not hard at all...worked like a charm!
Other Parts Used:
Was this helpful?
Thank you for voting!
door shelf useless
0 of 9 people
found this instruction helpful.
-
Joel from Spring Green, WI
- Easy
- Less than 15 mins
Decide how to snap end cap into door.
Put one end on door.
Fasten bar, then with other end cap
in the bar, snap it into the door.
Put one end on door.
Fasten bar, then with other end cap
in the bar, snap it into the door.
Was this helpful?
Thank you for voting!
awasome
-
chris from springfield, GA
- Really Easy
- Less than 15 mins
After reading reviews I was not sure but I ordered part on Wensday in the AM and I had the correct part Thursday evening this company rocks thank you by the way i paid for regular shipping I will order again in a heartbeat
Was this helpful?
Thank you for voting!
freezer would not freeze longer than one day. after ten years without problem
-
ronald from deering, NH
- Really Easy
- Less than 15 mins
pulled out freezer, went to floor,reached in next to compressor pulled off clip just like on the video.Pulled off old capacitator took off wire leads.Installed new one. Freezer runs great.Loaded it up with beef pork and venison. No problems.
Was this helpful?
Thank you for voting!
Broken shelf end cap
-
Donn from Saint PAUL, MN
- Really Easy
- Less than 15 mins
Truly a 10-second fix.
Was this helpful?
Thank you for voting!
compressor wouldn't start
-
Mike from Kilgore, TX
- Really Easy
- Less than 15 mins
I used a pick to remove the lugs from the old starter. Clicked them right in the new one and it went to woking!!!
Other Parts Used:
Was this helpful?
Thank you for voting!
Broken door handle.
-
John from Camarillo, CA
- Really Easy
- Less than 15 mins
-
Screw drivers
The important part was the parts delivery. Ordered one afternoon received the next afternoon. Very impressive!!
Was this helpful?
Thank you for voting!