FES355ASB Frigidaire Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Stove door switch was broken
-
James from Milford, IN
- Really Easy
- Less than 15 mins
-
Screw drivers
used two flat bladed screw drivers to get under edge of switch.. pried one side up and unit popped loose... removed electric connection (three prong recep) and plugged in new switch ..pushed into hole and was done... approximately 3 minutes..
Was this helpful?
Thank you for voting!
element not heating right
-
sharon from Summerton, SC
- Really Easy
- Less than 15 mins
Took old one out and plugged the new one into place.
Was this helpful?
Thank you for voting!
Oven was not heating up to the set temperature. Stopped around 180-200F.
-
Robert from Glasgow, MT
- Really Easy
- Less than 15 mins
-
Screw drivers
Removed 2 screws holding old temperature sensor inside the oven and gently pulled out the wire till the connector came through the hole. Disconnected old probe and attached new one. Fished the wire back in the hole and replaced the two screws. Then followed the operating instructions for calibrating the oven. Ended up setting it +5 deg
... Read more
rees. So far, works great.
Read less
Was this helpful?
Thank you for voting!
Could not find drip plates in local stores
-
Pat from Hendersonville, NC
- Really Easy
- Less than 15 mins
Just put the drip plates in stovetop and worked perfectly
Other Parts Used:
Was this helpful?
Thank you for voting!
Needed new drip bowls
-
Judith from Jewell, IA
- Really Easy
- Less than 15 mins
The hardest part of the job was cleaning under the old rings. Cook top looks new again!
Other Parts Used:
Was this helpful?
Thank you for voting!
burner was not heating properly
-
Marilyn from Dasssel, MN
- Really Easy
- Less than 15 mins
I ordered the element. When it arrived, I simply removed the old one and put in the new one. However, it did not completely solve the problem. The heat is now distributed evenly, but still have to turn the burner to 7.5 to boil water.
Was this helpful?
Thank you for voting!
drip bowl purchased at local store was wrong size
-
james from lockport, NY
- Really Easy
- Less than 15 mins
purchased correct part from PartSelect and it fit like a glove!
Was this helpful?
Thank you for voting!
Weld Was Broken On Support Bracket On Element
-
GEORGE from ADAMSVILLE, OH
- Really Easy
- Less than 15 mins
Replaced element no problem?
Was this helpful?
Thank you for voting!
drip pans old and rusted
-
linda from decatur, AL
- Really Easy
- Less than 15 mins
unplugged the elements, removed drip pans, replaced with new drip pans. plugged back in elements. took no skills or effort. the parts were ordered on-line one afternoon and were on my doorstep the next morning. I had been unable to find drip pans that fit my stove and was thrilled that they fit and came so quickly and were reasonably pric
... Read more
ed.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
8" left front surface element would no longer heat properly
-
Robert from Greencastle, PA
- Really Easy
- Less than 15 mins
I ordered the exact replacement element, and after unpacking it, it took about 5 minutes (actually,less; didn't time it), and the new element was installed and working fine.Thank you very much.
Was this helpful?
Thank you for voting!
drip bowls on stove rusty
-
Kenneth from Osseo, WI
- Really Easy
- Less than 15 mins
they were for my 90 year old mom. she dropped them in by herself, perfect fit....thanks very much
Other Parts Used:
Was this helpful?
Thank you for voting!
Door gasket was worn, stained and needed replaced
-
BETSY from HENDERSONVILLE, NC
- Really Easy
- Less than 15 mins
Gasket has pins that line up with tiny holes around the perimeter of door. Just pull the old gasket off, and snap new one ( with pins) in . Used the butter knife to push ends of gasket in hole at bottom of door. Took about 2 minutes to complete and looks AWESOME! simple. simple, simple! This company ships immediately and the product is d
... Read more
escribed properly. I would buy from this company again!
Read less
Was this helpful?
Thank you for voting!
burner burned out
-
Charles from Kettlersville, OH
- Really Easy
- Less than 15 mins
unplugged old burner plugged new one in
Was this helpful?
Thank you for voting!
Heating element burned out
-
Jack from Hedgesville, WV
- Really Easy
- Less than 15 mins
-
Screw drivers
Took screws loose, unplugged old one plugged in new one put screws back
Was this helpful?
Thank you for voting!
Drip Bowl Replacement
-
Jennifer from Arena, WI
- Really Easy
- Less than 15 mins
I could not find the larger size universal drip bowl to fit the 8" burners on my stove. This product replacement is perfect.
Was this helpful?
Thank you for voting!