Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Oven would not get up or stay up to selected temperature
0 of 1 peoplefound this instruction helpful.
wondell from Winnemucca, NV
Easy
Less than 15 mins
Nutdriver
Pull stove out to get behind it,unplug temperature probe plug. Remove temp probe from oven by removing the screw holding it in place on back of oven. Cut plug off temp probe unit leaving as much lead wire as possible on plug end. Strip wires on new probe and end of plug wires(one quarter inch). Then I used two small butt connectors to joi
... Read moren the stripped wires,one for each pair of wires. Two small wire 'nuts' may also be used as the connections are outside the oven and not exposed to the heat of the oven while it is in operation. Hope this helps the inexperienced 'do it yourselfers'--:)
First i removed the drawer. Then i removed the broken drawer glide and replaced it with the new one. Then i put the drawer back! The parts were a perfect match...
Was this helpful?
Thank you for voting!
Broken drawer glide
0 of 1 peoplefound this instruction helpful.
Myles from Twin Falls, ID
Really Easy
Less than 15 mins
Screw drivers
I used a screw driver to pop the broken glide out and then snapped in the new one. The repair took all of about 30 seconds. It probably would have taken even less time if the former owner had not epoxied the broken piece in place.
Was this helpful?
Thank you for voting!
I accidently threw away the drawer glide, when it fell off one day b/c I didn't know what it was. Later on when I started pulling out the bottom stove drawer, I discovered that it wasn't gliding properly....duh...
0 of 1 peoplefound this instruction helpful.
Reginal from Tampa, FL
Really Easy
Less than 15 mins
I just placed the new glider in place and put the drawer back on its hinges and it was good to go... my wife was extremely happy
Was this helpful?
Thank you for voting!
drawer glides went in with just a push with a finger ,works great
0 of 1 peoplefound this instruction helpful.
carl from mashpee, MA
Really Easy
Less than 15 mins
pushed the glides in the proper holes and ,they work great now ,drawer opens and closes as easy as it should. will buy from again.
Was this helpful?
Thank you for voting!
Broken drawer glide
0 of 1 peoplefound this instruction helpful.
Mary from North Beach, MD
Really Easy
Less than 15 mins
Simply secured new glide into slot. I was more impressed at how easy this company made it for me to find the part I needed. And, they shipped immediately. This company is great.
Was this helpful?
Thank you for voting!
Drawer Guides Broken
1 of 4 peoplefound this instruction helpful.
Charles from Petersburg, VA
Really Easy
Less than 15 mins
New ones just snapped into place it takes less than a minute
Was this helpful?
Thank you for voting!
Lens cover for oven light broke.
0 of 1 peoplefound this instruction helpful.
Amy from Corona, CA
Really Easy
Less than 15 mins
Really a no brainer, but I do have to say that PartSelect customer service is excellent. My part was located and on it's way within a day and arrived a couple of days later.
Was this helpful?
Thank you for voting!
Broken-Missing Front Drawer Glides
0 of 1 peoplefound this instruction helpful.
Michael from Anchorage, AK
Really Easy
Less than 15 mins
They snap right into place in the holes at the front of the stove and the drawer is then slid back onto the glides and works properly once again.
Was this helpful?
Thank you for voting!
broked drawer slide
0 of 2 peoplefound this instruction helpful.
Thomas from Spring Hill, FL
Really Easy
Less than 15 mins
Screw drivers
The plastic drawer slide that the lower stove door sits on broke. (one on each side) Remove the old one with a screwdriver and snap in the new one, took 1 minute because I replaced both of them. Excellent fast delivery. 5 stars !
Was this helpful?
Thank you for voting!
lower drawer drags on floor
0 of 2 peoplefound this instruction helpful.
columbus from birmingham, AL
Really Easy
Less than 15 mins
Screw drivers
remove/pry broken plastic glide from in-side of oven,( wall not drawer ) and install new one.
Was this helpful?
Thank you for voting!
Rear door glides and both broken off completely
0 of 2 peoplefound this instruction helpful.
Carol from Crossville, TN
Really Easy
Less than 15 mins
Screw drivers
Part of one of the glides was still inside the hole so had to use a screwdriver to push it on out and simply put the new glides in both rear holes "very easily". Sure am glad I found this site on line. If anything else goes wrong, I will surely contact this site. Thanks. The speedy service was wonderful too. Got it in two days! Caro
... Read morel A. Lawless
Read less
Was this helpful?
Thank you for voting!
broken drawer slide clips
0 of 2 peoplefound this instruction helpful.
Richard from Spokane, WA
Really Easy
Less than 15 mins
Easy peasy! Took all of 2 minutes to replace all four clips. Clips snap in by hand and take a little bit of force to make them seat correctly. These are a frequently-replaced item,so that makes me think they are somewhat fragile. Great prices and quick shipping from PartSelect made this so simple. The local appliance parts dealer wanted $
... Read more11.00 each for the rear clips! Thanks!
The plastic piece broke and I had to replace it to hold the drawer in place
0 of 2 peoplefound this instruction helpful.
Carrie from Torrance, CA
Really Easy
Less than 15 mins
Snapped in the plastic piece after I actually ordered the right piece....wasn't paying enough attention when ordering and didn't have a book that showed the image so I could make sure....went off the image on your website......which is awesome. Totally my fault. Thank you for your wonderful service.
My Orders
