FEC32S6ABC Frigidaire Cooktop - Instructions

Open range door remove 2 screws on bottom of stove top remove top

Remove the 3 screw on the bottom cover, and 2 screw holding the switch and then switch your wires out.

After turning off the power to the unit, we took it out of the countertop and unscrewed the base of the unit. We then unplugged the damaged coil and plugged in the replacement part. We then screwed the base of the unit back on and replaced the unit in the countertop. The largest burner now works.

Shut power off to appliance. Replaced burner switch. Removed three screws in access panel to get to switch. Removed two screws that held switch in place. Removed wires from old switch and attached to new switch. Replaced switch screws and then replaced access panel screws. Easy fix. Saved an $85.00 service call fee.

Very simple, just removed three screws and pulled the top out and turned over and then removed the two screws holding the support bar. Removed and installed the element.Surprised to see that the element burned out in such a short time.

I ordered the 8" burner switch and two of the screws! I flipped the surface top up side down and removed 2 screws that held the cover over all the switches. I flipped it right side up to remove the 2 screws in the bad switch, flipped it over again to switch the wires from bad switch to new one, being careful to keep the letters and number ... Read more s matched. Replaced the 2 screws on top side and replaced the cover on the bottom and went back to cooking! Very easy!

Easy to put in but i droped a screw to hold the element. had to pull another screw to fix it

After removing pots / pans in cabinet below cook top and turning off the power, I was able to remove the panel held by 2 screws. Pulling the old light out was just a little difficult as it came in pieces. New one popped right in, hooked up terminals, replaced the panel and that was it !!

hinged burner up to the rear. removed hex nut to unmount old switch. 5 wires pushed onto new switch same orientation.mounted switch with 2 very short screws no problem very easy. turned breakers on checked operation a- ok.