FD501D-FS00 Kawasaki Engine - Parts

This is a genuine replacement part for Kawasaki 4 stroke engines. The pressure cap assembly is designed to fit onto the radiator assembly and act as an access port to add or remove coolant directly from the radiator. This replacement cap is made of high-quality materials. This item is sold individually.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Kawasaki engines commonly installed on lawn and garden equipment. This is an identical replacement for a missing or worn gasket that helps to provide an air-tight seal for the water pump, over time the material tends to deteriorate and it ...Read moremay begin to crack eventually requiring a replacement. It is a high-quality composite material component which is sold individually.

This bolt is generally used to secure muffler on engines. It is supplied from original equipment manufacturer for use with Kawasaki gas powered engines. This bolt has a hex head which requires a wrench for installation. Please note it is sold individually.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Kawasaki engines. The ignition coil generates the voltage for the spark plug. This part comes with the ignition wire and module. For this installation, you will need a screwdriver to remove the any engine shrouds or covers, as well as needle nose pliers to disconnect the ignition coil from the engine.

This flanged bolt is a genuine OEM steel fastener used to secure various components in outdoor power equipment. It features a flange base that acts as a built-in washer to distribute the load and prevent damage to the material it is fastened to. The bolt head has a diameter of 6mm, and the bolt shaft has a thread pitch of 20. The bolt can...Read more corrode and crack over time, or its threads may wear down, leading to loosening or detachment of the connected parts. You will likely note excessive noise, vibrations, and equipment instability. Inspect all the bolts in your equipment and replace those that are no longer functioning. Use a wrench or socket to loosen and remove the old bolt. Position the new bolt on the mounting surface and tighten it securely until the flange is flush against the surface. Each flanged bolt is sold individually.