FCM7WNBWH General Electric Freezer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
fan and compressor wont start
-
JOSE from NEW YORK, NY
- Really Easy
- Less than 15 mins
-
Screw drivers
Googled the model number of refrigerator with symptoms of "refrigerator wont run". Parts select web site appeared on my screen, opened Parts Select website, Partselect said probable cause of my frige symptom was that the run capacitor usually burns out 51% of the time. They were correct with the diagnosis 100%. I ordered the run capacito
... Read more
r for $23.00, installed it in 10 minutes, refrigerator runs good as new. Thank you for saving me cost of service call. I probably saved $200 or more. I will use Partselect again with my next problem. THANK YOU,
Read less
Was this helpful?
Thank you for voting!
all power to refrigerator quit
-
Paul from Irving, TX
- Really Easy
- Less than 15 mins
-
Screw drivers
layed fridge face first on a chair removed cover with flat head screwdriver unplugged part replaced with new part replaced cover returned to upright and plugged in
Was this helpful?
Thank you for voting!
compressor running and hot, refer and fridge room temp.
-
Charles from Durham, CA
- Really Easy
- Less than 15 mins
Watched a youtube on capacitors- though on a motor with a pulley, the symptoms were the same, motor running and pulley not turning-bad capacitor. Took a chance for a 17+ dollar part vs a new compressor. It worked.
Was this helpful?
Thank you for voting!
Needed to create a 10" Keezer collar for chest freezer.
-
Normand from Warren, MI
- Easy
- More than 2 hours
-
Screw drivers
Cut 1'x10'x10" select pine board into 4 pieces. Attached the four pieces using the Kreg Jig Jr to each other. Stained and polyurethane for appearance. Added EDM weather strip to bottom edge of collar. Disconnected hinges and removed lid from freezer chest. Placed collar on top of chest freezer then placed lid on top of collar. Carefully a
... Read more
ligned collar to freezer and lid to collar. Attached existing hinge of lid to collar, then mounted new hinges to existing freezer mount location then attached new hinges to collar. Double hinged collar. Nice!!!! Not a repair but an improvement.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Both the fridge aqnd freezer would not get cold.
-
Mary from Farmingdale, NY
- Easy
- Less than 15 mins
-
Screw drivers
Easy. Followed the video instrucations. the part was right there next to the compressor.
Was this helpful?
Thank you for voting!