F21PL2 (Type 0) Bostitch Nailer - Parts

This is a genuine Bostitch replacement part that fits all BT brad nailers and all S32 staplers. If trigger leaks air or if tool misfires often, try replacing trigger valve. This kit contains one (1) each of: valve assembly (including both O-rings), lubricant, spring pin punch, and repair instructions. Please note that two (2) O-rings are ...Read moreincluded but can also be purchased separately as parts # 106967 and # 86459. O-rings are easily damaged and worn out, causing tool issues, so it\\\'s a good idea to have a backup or two on hand. Only a hammer is needed for this repair.

This is a genuine manufacturer sourced replacement part designed for use with Bostitch staplers. The purpose of this piston bumper is to keep the piston from hitting the bottom of the cylinder and damaging it. Because this part get so much abuse it has a tendency to crack and fall apart. If you see any pieces of this bumper falling out fr...Read moreom your nail gun, it is definitely time to replace it. This item is made out of plastic material and it is sold individually.

This is a Genuine OEM replacement part used on some Bostitch Nailers. This part is made out of Plastic and it is Sold Individually. A utility hook can be used as a belt or rafter hook to make tool accessible.

This is an authentic OEM part which is designed for use with Bostitch nailers. It is a special hardware which helps to secure the trip foot. This is an identical replacement for a damaged or a faulty part that was installed on a new unit. Check the appropriate diagrams for your model for the exact location and the correct application of this clip. One durable plastic trip foot clip is included.

It is an authentic replacement part that is sourced directly from original equipment manufacturer for Bostitch nailers. This wear guide is secured to the machining frame cap to act as a cushion for the tool as it is positioned against the material. It is made of durable rubber material and it is sold individually, please note the wear plate is sold separately.

This compression spring is an OEM direct from Bostitch. The metal spring is compatible with many stapler and nailer tools. This item is fitted within the trigger valve kit of the device. The spring is the mechanism for the trigger to move back in place. Although this part is sold individually, it can also be found in the SEQ6 Kit. A small hammer and a hex key are helpful in the repair.

This replacement screw is a high quality item that has multiple uses depending on the model of your tool, please make sure to check appropriate diagrams for correct location and use of this hardware. It is a genuine screw that is sourced directly from original equipment manufacturer for use with nailers and staplers. Note this durable metal hex socket head screw is included per order.

This authentic OEM sourced replacement part is designed for use with Bostitch nailers. It provides spring action for the magazine. It is made out of metal with a plastic hub and it is sold individually. To complete this repair you would need a screwdriver.

This item has been sourced from the original manufacturer to be used with pneumatic nailers from Bostitch. The trip foot attaches to the lower end of the contact arm and is used to provide a contact point that will not mar the material being nailed. This item is available as an individual replacement part.

This is a genuine Bostitch part sourced directly from the manufacturer for use in nailers. The exhaust deflector goes between the exhaust deflector bushing and the cap plate. An allen wrench may be necessary during the installation of this item. It may become broken and will need to be replaced. This is available as an individual replacement part and is made of plastic.

This item has been sourced from the original manufacturer to be used with pneumatic nailers from Bostitch. The head valve seal is used to prevent air from leaking between the cylinder and the head valve. This item is available as an individual replacement part.