F20BBA Whirlpool Freezer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Frozen items on top of freezer not quite frozen, bottom of freezer ok. Freezer alarm sounding.
27 of 42 people
found this instruction helpful.
-
Randall from Burlington, WI
- Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers
Disconnect power / Remove shelves / remove sheet metal panel in rear of freezer / disconnect fan wires / remove fan unit using nut driver. / reassemble.
Was this helpful?
Thank you for voting!
Coil inside freezer kept "icing" over, causing little to no air flow. This was causing the food to thaw while in the freezer.
2 of 2 people
found this instruction helpful.
-
Arthur from LAKE VILLAGE, AR
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers
After viewing a video by Parts Select, I pulled freezer from the wall to gain access to the back where the timer is located. I unplugged the freezer from the wall outlet. I then located the timer and used a screwdriver to turn the plastic screw on timer until it clicked once. I then waited a few minutes to see if heating elements would
... Read more
start working. When I heard water sizzling of the elements, I concluded the timer was bad. I then purchased a new timer from Parts Select and replaced it by removing the 2 screws holding it in place. I unplugged old timer and plugged in the new timer, reinstalling it onto the freezer. My 17 year old freezer is working like new again. Thank you Parts Select for everything.
Read less
Was this helpful?
Thank you for voting!
Not freezing or keeping cold and no fans or motors running
-
Glenda from Chester, MT
- Easy
- 15 - 30 mins
-
Pliers, Socket set, Wrench (Adjustable)
I had the best luck using pliers to remove the hex top screws. Once the screws were removed I unplugged the old defrost timer and plugged in the new one. Replaced the screws and the freezer worked when plugged in.
Was this helpful?
Thank you for voting!