EY41B Admiral Freezer - Parts

Sold individually.

This screw is well under an inch long, and is made of metal.

This defrost evaporator and water collection pan is almost sixteen inches long. It is all black in color and it is made entirely of plastic.

This metal freezer door key fits upright freezers. It has a cross shape and is approximately 2 inches long. If your freezer door will not stay shut, you can lock the door to keep it closed. If your key will not lock, or unlock the freezer door; check to see if it has been damaged or bent. If the key is damaged, you should look to replace ...Read moreit to avoid damaging the lock. The key should engage the locking mechanism with ease. If the lock sticks when you turn the key, use penetrating fluid to loosen the mechanism. These keys are sold individually, and should be stored somewhere safe and not next to the unit.

This bushing is used with a 1/4-inch pin. This part is found in refrigerators (and sometimes freezers). The bushing provides a bearing surface for the hinge pin that rotates. Every time you are opening and closing your fridge, this part is acting as a bearing and makes it so that the door is swinging back and forth with ease. This bushing...Read more tends to wear down over time and will need to be replaced. You will notice that this part needs to be replaced if your door is off-kilter and not aligned properly. This part is sold separately. This is a genuine part sourced from the manufacturer directly.

This ice dispenser yoke is an inch and a half long. It is made of metal and is used with the ice enclosure of a refrigerator's icemaker assembly.

Sold Individually.

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.

The door hinge shim helps maintain proper door alignment.

This part is a temperature sensing devise. It senses the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted. It is calibrated to permit a defrost cycle only when the temperature is below a preset temperature

This gate support is designed to support the gate or fence on your vertical freezer. This part is designed for the right-hand side and differs from the left-hand side gate support. Be sure to note which side of your gate support is damaged before ordering this part. This product is sold individually. It is white in color and is made entir...Read moreely of plastic. The gate support is approximately 6.5 inches in length and slightly less than an inch in width. This is an OEM part sourced directly from the manufacturer.

This door hinge washer is less than an inch in diameter. It is all white in color and it is made entirely of plastic.