EW3LGF65GSB Electrolux Range - Parts

This genuine OEM oven probe is also known as an oven temperature sensor or range probe. This part is manufactured for a range, stove, or oven to detect the temperature within the oven cavity. The probe allows the oven to maintain the set temperature by sensing the temperature and sending the information to the ovens motherboard. You may n...Read moreeed to replace this part if oven is not heating or is heating unevenly. Be sure to disconnect power to oven before replacing, as it is an electrical part. Tools needed are 1/4 inch nut driver and needle nose pliers.

This gas oven bake igniter is designed to initiate the heating process by activating the burner during baking cycles. It functions by heating up until it reaches the ignition point, allowing gas to ignite and maintain consistent oven temperatures. A failing igniter is a common cause of heating issues, including longer preheat times, uneve...Read moren baking, or complete failure to heat. Replacing the igniter restores proper oven function and ensures reliable performance. Installation should be performed with the appliance disconnected from power and gas supply for safety.

Order quantity needed.

The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, or stove from tipping when force or weight is applied to an open oven door. The bracket is secured to the floor and wall and fits over the rear leveling leg in ...Read morethe back of the appliance, in a cutout specifically designed for the anti-tip bracket. This part is very essential to the safe operation of the appliance. Failure to install the bracket properly can result in the oven tipping or falling and causing injuries.

Sold Individually. These legs should be adjusted to make your appliance level on uneven flooring.

This steel washer is also known as the range washer and is used on your oven door. The measurements for the steel washer are a three quarter inch outer diameter, and a one quarter inch inner diameter. This washer is an OEM part, made of steel, which is sourced directly from the manufacturer. This specific steel washer is used with your ra...Read morenge, to secure the inner and outer door together and to secure the oven door handle back in place. Users have ranked this repair as a simple installation that should take you less than fifteen minutes to complete.

Sold Individually.

This part is sold individually. The leveling leg is black in color and measures approximately 2 inches in length. It is made of plastic. The leveling leg is found underneath your range and may crack or wear down over time. This will need to be replaced if it has broken or gone missing. If you notice your oven is wobbling or uneven it may ...Read morebe due to the leveling leg needing to be replaced. This part can be adjusted to accommodate different heights due to uneven flooring. This is a genuine OEM part sourced directly from the manufacturer.

Sold individually.

This oven bottom panel is a genuine OEM replacement designed to protect the bake element in gas ranges from spills, drips, and debris. Positioned above the bake burner, it acts as a barrier that helps prevent damage while promoting even heat distribution throughout the oven cavity. Crafted to manufacturer specifications, the panel support...Read mores consistent cooking performance and extends the life of internal components. It is ideal for replacing warped, stained, or damaged panels that may affect heat flow or cleanliness. Installation is straightforward and typically involves sliding the panel into place above the burner. Always verify your appliance’s model number to ensure compatibility.

Sold individually.