EB5300TH Makita Leaf Blower / Vacuum - Parts

This genuine OEM woodruff key is a small, semicircular metal piece used in various power tools to connect rotating parts, such as shafts or gears, to other components like wheels or pulleys. It prevents slippage between these parts, ensuring smooth synchronization and power transmission. With a width of 3/32 inches and a length of 5/8 inc...Read morehes, consider replacing a woodruff key if you notice misalignment or excessive movement between the connected parts. Be sure to inspect the key for signs of wear, damage, or bending. Removing the key depends on the make and model of your tool. If the key is visible, gently tap it from one side using a small hammer and a punch or drift pin. This will dislodge it from its slot. If the key is stuck or difficult to access, you may need to partially disassemble the tool to gain better access to the key. Once the key is loose, carefully pull it out using pliers. Clean the keyway and slot before installing the new key. Before making your purchase, remember that this component is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The gasket is commonly found in Makita yard tools such as trimmers, brushcutters, and blowers. This part is made of flexible plastic, and is used to seal the connection in the carburetor with the pump body. You will require a screwdriver when replacing this part. This item is sold as an individual replacement part.

The oil cap attaches to the gasket and is made of plastic. This is an OEM part sourced directly from the manufacturer and used in blowers and trimmers made by Makita. This part is available as an individual replacement. No tools should be necessary during installation. It will need to be replaced if it breaks.

"This is an authentic throttle lever by Makita. It is red in color and is used to increase and decrease the speed of the engine. It allows you to adjust the speed to one of three options: low speed, medium speed, and high speed. When starting up the blower always check the throttle lever for smooth and easy action. If your throttle lever...Read more is not working as it should or appears damaged, it will need to be replaced. Before replacing the throttle lever in your leaf blower, remove the wire and boot from the spark plug to prevent the engine for starting. Unthread the screws holding the handle in place. Separate the two sides of the handle. This should give you access to the throttle lever for removal. "

This OEM throttle link is a part found in a backpack blower. It is located between the throttle lever and lever case. To access this part, you will start with removing the screws that hold the lever case together.