DWE402W DeWALT - Overview

Genuine Dewalt replacement part used on Small Angle Grinder. This brush has a lead wire attached and it is Sold Individually. It is always best to replace both brushes, even if only one is worn. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through frict...Read moreion and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This genuine manufacturer supplied replacement part is specially designed for Dewalt angle grinders. This handle is secured to the side of the tool providing user with a safe and comfortable grip for operating the tool. It is made from high quality plastic with a threaded metal shaft and it is sold individually.

This is a Genuine Manufacturer Sourced replacement part used on Dewalt Angle Grinders. The purpose of this Clamp Washer is to provide support for the Grinding Wheel to the Spindle Shaft. This Clamp Washer is made out of Metal and it is Sold Individually. You would need Hex Wrench to replace this part.

This is an original replacement part manufactured for use with DeWalt angle grinders. This two wire cord had a rubberized jacket, and the wires have crimped terminals to make installation easier. The cordset is available individually.

This is an Original Manufacturer Sourced replacement part used on Dewalt Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Hex Hole Flange Nut is to hold the Grinding Wheel to the Spindle Shaft. You would need Hex Wrench to secure this part.

This screw is commonly used on a variety of power tools. It is a genuine OEM sourced replacement part. Please make sure to check appropriate diagrams for correct location and use of this screw. Includes one pan head screw per order. You will need a screwdriver to install or remove it.

This part is sold individually. The o-ring goes on the guard and is made of rubber. A set of pliers and a screwdriver might be needed during the installation process. It may become broken and will need to be replaced. This part is an OEM from DeWALT for use in grinders.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This is a genuine OEM part. The DeWALT guard is constructed of metal, and is made for use with several angle grinder tools. This component is fastened between the gearcase assembly and the clamp washer, providing protection to the operator and the blade. The guard is sold individually. A hex wrench is required for the removal and replacement.

An authentic item that is supplied directly from the original equipment manufacturer for use with DeWALT small angle grinders. The switch allows a user to turn the tool on and off with a simple push of a button, over time components may wear out and begin to fail eventually requiring a replacement. It has a durable plastic housing and is ...Read moresold individually, keep in mind the paddle assembly and other parts are all sold separately.