DWE4011 DeWALT - Overview

This is a Genuine Manufacturer Sourced replacement part used on Dewalt Angle Grinders. The purpose of this Clamp Washer is to provide support for the Grinding Wheel to the Spindle Shaft. This Clamp Washer is made out of Metal and it is Sold Individually. You would need Hex Wrench to replace this part.

Genuine Dewalt replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a ...Read moremotor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is an Original Manufacturer Sourced replacement part used on Dewalt Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Hex Hole Flange Nut is to hold the Grinding Wheel to the Spindle Shaft. You would need Hex Wrench to secure this part.

Improve control and comfort during demanding applications with this side handle, designed to provide a secure secondary grip for enhanced stability and handling. By helping reduce user fatigue and improve tool control, it supports safer, more precise operation during grinding, sanding, polishing, and other high-torque tasks. A damaged, wo...Read morern, or missing handle can make the tool more difficult to control, making replacement an important part of maintaining safe operation. Installation is quick and typically involves threading the handle into the designated mounting point on the tool. Refer to your tool's owner's manual to confirm compatibility and proper installation. Sold individually.

This replacement guard is designed for use with Dewalt angle grinders. It is a high quality item that is sourced directly from original equipment. This part helps to direct dust and trimmings away from the user as well as provide protection from the grinding disk. This part is made from durable metal and it is sold individually.

This replacement guard is designed for Dewalt grinders. It is a high quality item sourced from original equipment manufacturer. This part helps to direct dust and pieces of material away from the user as well as provide protection from the grinding disk while the tool is being used. Please note, one metal guard is included per order.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This plastic switch is supplied by the original manufacturer. It is used in DeWALT small angle grinders. This is a push-button switch controlling on-off functions. One (1) switch is included. Please note that linkage and button slider are sold separately. • Disassemble housing • Remove wiring from the old switch • Disconnect switch from linkage • Reconnect new switch and reassemble housing