DWE1014 (Type 1) DeWALT Electric Drill - Parts

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This holder is sourced from the original manufacturer for use in hammer drills. It is yellow in color, and measures 7 inches in length. The holder is responsible for holding the chuck key when it is not in use. The holder fits onto the body of the drill and ensures that the chuck key is easily accessible and safely stored. Replace the hol...Read moreder if it is lost, damaged, or unable to hold the key. The holder and chuck key are sold separately.

This is an original part sourced directly from DeWalt. This grease was designed for use with the equipment listed below and helps to lubricate the system. This extends the life of the tool and protects parts from usual wear by allowing for easy movement. This item is sold individually.

This is a replacement part directly sourced from the manufacturer for use in drills, hammers, grinders, sanders, jigsaws, and trimmers made by DeWALT, Porter Cable, Black & Decker, and Bostitch. It connects to the power cord and is made out of metal. This part is extremely small and will need to be replaced if it becomes lost or if it breaks. The terminal is sold individually.

Genuine Dewalt replacement part, this item is sold individually. The purpose of this Cord Clamp is to hold the cord in place inside the tool to keep it from pulling out. It is installed just inside of the handle. There are two screws used to hold the Cord Clamp in place. The part number for the screw is different depending on your model number.

This replacement chuck key is an authentic manufacturer sourced part that is specially produced for use with Dewalt and Black and Decker drills. The chuck key is designed to allow the user to tighten and loosen the jaws of a drill chuck. It is made of durable, high quality metal and it is sold individually.