DWD216G (Type 1) DeWALT Electric Drill - Parts

This is a genuine OEM sourced replacement part designed for use with a variety of power tools. Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. It is made out of rubber and it is sold individually.

This is an authentic replacement part manufactured for use with DeWalt power tools. The ID Label is a sticker of the DeWalt logo and is often needed when the tools housing is replaced. This logo is sold as an individual replacement part, please see model diagram for associative parts.

This replacement item is commonly used on angle grinders and hammer drills. It is sourced from original equipment manufacturer. The purpose of a ball bearing is to reduce friction between two connected rotating parts. Bearings are constantly under heavy pressure. Over time they would wear out and would need to be replaced. This item is sold individually.

This is an original part sourced directly from DeWalt. This grease was designed for use with the equipment listed below and helps to lubricate the system. This extends the life of the tool and protects parts from usual wear by allowing for easy movement. This item is sold individually.

This screw is s a standard hardware which has multiple uses based on equipment. It is a genuine OEM sourced part, not an aftermarket equivalent. It is commonly used on a variety of Black and Decker and Dewalt power tools. Please make sure to check appropriate diagrams for correct location and applications for this item. It a metal screw t...Read morehat is sold individually. You will need a torx screwdriver to tighten or loosen this screw.

This is a Genuine OEM Authorized replacement part used on DeWALT Power Tools. This item is made out of Metal and it is Sold Individually. This is a Standard Hardware Screw which is generally used to hold two pieces of housing together. Requires a Phillips Screwdriver to tighten or loosen this Screw.

The armature attaches to the bearings. It is a genuine OEM sourced part which is specially designed for use with DeWALT drills. Keep in mind this item is sold individually. During replacement, it may require a screwdriver to help install this part correctly. It is made out of metal and will need to be replaced if it breaks.

This is an authentic replacement part manufactured for use with DeWalt drills and hammer drills. The special handle set is used to house the switch and field case. This handle set comes with both halves and is sold as an individual replacement part, please see model diagram for associative parts.