DW708 (Type 1) DeWALT Miter Saw - Parts

This is an authentic DeWALT replacement part. The drive pin is designed by the manufacturer for use in crosscut miter saws. This part is made of metal, and is used to secure the pivot shaft to the table, allowing the angle of the saw head to be adjusted. You may require pliers when replacing this part. This item is sold individually.

This is an authentic DeWALT replacement part. The dome plug is found in crosscut miter saws. This part is made of high-quality plastic, and is used to fill a hole in the blade guard. When replacing this item, you may require a flat-head screwdriver to pry the old part loose, and then the new part can be slotted into place. This item is sold individually.

This is an authentic DeWALT replacement part. The washer is found in miter saws and lawn mowers from DeWALT and Black & Decker. This is a metal part, generally used to secure and protect the connection with a screw or bolt. It may be located in different parts of the machine, depending on model. Please be aware that there are differen...Read moret washers used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require a screwdriver or wrench when replacing this part. This item is sold individually.

This is a Ball Bearing that has seals on both sides. This is a genuine DeWalt replacement part that is sold individually. rnrn • Ball bearings minimize friction between 2 parts in your tool that would otherwise spin and rub against each other. The balls or rollers take the load and spin, distributing the weight evenly while the minimal ...Read morecontact area of the balls reduce friction. This reduces wear on the tool and allows it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine OEM sourced component which is specially designed for use with air compressors. A strain relief is designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. It is an identical...Read more replacement for a missing or a faulty part that was installed on a new unit. Please make sure to check the owner's manual and the appropriate diagrams for your model for the correct installation of the new bushing strain relief. Keep in mind this high-quality rubber part is sold individually.