DW511R (Type 6) DeWALT Hammer Drill - Parts

This is an OEM part sourced directly from the manufacturer. This 17.64 oz container of grease is used to lubricate the system of DeWalt equipment in order to protect the inner working parts and extend the life of the tool. One container is included per order.

This is a genuine replacement part sourced from the original manufacturer for use with hammer drills. The special seal is used between the gearcase cover and the gearcase assembly. This seal is available as an individual replacement part, please see model diagram for associative parts.

This replacement chuck key is an authentic item that is sourced directly from original equipment manufacturer for use with Dewalt hammer drills. The purpose of a chuck key is to tighten and loosen the jaws of the chuck that holds the drill bit. It is made of durable, high-quality metal and it is sold individually.

This is a genuine DeWALT replacement part. The O-ring is commonly found in power tools such as hammer drills and angle grinders. This part is made of flexible plastic, and is generally used to seal and cushion the connection between components. It may be found in various locations in the machine, depending on model. Please be aware th...Read moreat there are different O-rings used in the machine. Refer to the parts diagram to be sure of ordering the correct part. This item is sold individually.

The chuck attaches to the gear case and is made of metal. The chuck & key are sold together as a set. These are genuine Porter Cable and DeWALT parts sourced directly from the manufacturer for use in drills. Over time these parts may break and will need to be replaced.

This is an authentic DeWALT replacement part. The brush holder is designed by the manufacturer for use in hammer drills. This part is made of high-quality plastic and metal, and is used to secure the carbon brush in place with the armature assembly. You may require a screwdriver when replacing this part. This item is sold individually.

It is an authentic OEM supplied item that is designed for use with Black and Decker and DeWALT hammer drills. The purpose of this component is to secure carbon brush that helps to conduct the current in an electric motor. Over time parts may wear out or get damaged eventually requiring replacement to maintain peak performance. It is a hig...Read moreh-quality assembly that includes one durable plastic brush holder with an attached metal spring. Check the diagrams of your specific model for the correct installation of this replacement part.

This Ball Bearing has metal shielding on both sides. This is a genuine Dewalt replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduc...Read morees wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is replacement ball bearing is a commonly used item on a variety of power tools. Bearings are specially designed to allow connected parts to rotate smoothly. The way it is build it will minimize friction between the rotating parts. This is a sealed metal bearing generally used with an armature. Includes one (1) bearing per order. St...Read moreeps to replace this bearing would be different from one model to another. However, general steps to complete this repair would be the same. You may need a screwdriver and pliers to finish this job. • Make sure the unit is unplugged • Remove the cover/housing • Disengage the brushes • Remove the armature • Remove the old bearing • Install the new bearing • Reassemble unit and test the equipment

This cord protector is a genuine DeWalt replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.