DW505K (Type4) DeWALT Hammer Drill - Parts

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This screw is a genuine Dewalt chuck screw. It is constructed of tough steel for long life. It has a beveled head with torx drive for a secure fit. This screw is reverse thread for securing drill chucks. It also has locking compound within the threads for an even tighter installation. This screw is commonly found in Dewalt cordless...Read more drills and it is compatible with the tools listed below. It is not guaranteed to fit any other power tools.

This is an OEM Manufacturer Sourced replacement part used on certain Hammer Drills. Includes One (1) Carbon Brush with wire lead attached. Please note: this brush is sold individually and most tools would use Two of these carbon brushes. It is always best to replace both brushes, even if only one is worn. Carbon brushes are one of the mo...Read morest commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This connecting ball is an authentic manufacturer replacement part used in various power tools. It is a stainless-steel ball that provides a pivot point that allows the attached components to move back and forth smoothly during use. If the connecting ball falls off or becomes loose, worn out, or damaged, the equipment will become unstable or unable to move at all.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with circular saws and hammer drills. The special retaining ring is commonly used to secure the fan to the armature's shaft. This item is available as an individual replacement part, please see illustrated diagram for associative parts.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

It is a genuine replacement screw that is sourced directly from original equipment manufacturer. This is a standard hardware that has multiple uses depending your tool. For correct location and use of this screw, please check appropriate diagrams. This torx screw is sold individually.

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.

Included in part number 585500-00