DU18J4B Maytag Dishwasher - Parts

This screw is sold individually.

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This is a heat-resistant adhesive for your appliance. The heat resistance allows you to stick parts such as grate feet, gaskets, and felt seals in hot areas, such as a cooktop, without compromising the integrity of the adhesive. It is white in color, and the tube is approximately 7.5 inches long.

Sold Individually.

This electrically operated propeller causes water to flow through your dishwasher's pump. This impeller is located above the dishwasher's mascerator blade.

This screw is well under an inch long, and is made of metal.

This screw is sold individually. Size: 8-32 x 1/4 inch.

This motor shaft seal kit does not include a macerator blade, but does come with wash and drain impellers(upper and lower).

This part is sold individually. This nut can be found in various appliances including a dishwasher, air conditioner, washer, dryer, range/cooktop, oven, freezer, range hood, and refrigerator. There is a serrated pattern along the edge of the nut, which helps to avoid loosening while the appliance is in motion. Nuts may corrode or rust ove...Read morer time and will need to be replaced. You will need a wrench to screw the nut into place. This genuine OEM part comes directly from the manufacturer.

This water tubing clamp keeps the 3/16-inch diameter water tubing mounted to your refrigerator. Its purpose is to prevent shifting, kinking, or loosening of the tubing, ensuring a consistent water flow for the water dispenser and ice maker. It is typically located at the back of the cabinet near the inlet valve. If the clamp securing the ...Read moretubing in your refrigerator is not properly secured, it can result in leaks or complete detachment. This poses a risk of water damage to your fridge, flooring, and nearby structures if not addressed promptly. To replace the clamp, refer to your user guide for its location. Then, use a screwdriver to remove the securing screw. Please note that this clamp is sourced directly from the original equipment manufacturer and does not include any additional hardware.