DP840CWDB4 Whirlpool Dishwasher - Parts

This panel is reversible, black on one side, white on the other side.

Sold individually.

This is a door latch bolt for a dishwasher. The door latch bolt fits on the top of the dishwasher door to keep the door closed while the appliance is running. The latch also prevents the dishwasher from running when the door is not closed, so your dishwasher may not run if the door latch bolt has been compromised. This part does not inclu...Read morede the latch lever, so consider ordering that part as well if necessary. It is made entirely of plastic, is black in colour, and is approximately 3.5 inches wide. To access the latch bolt, you will need to remove the inner door panel of your dishwasher.

This kit contains Impeller and Bearing Assembly.

The lower rack provides easy loading with flexibility for small and large items and helps hold the dishes in place during the wash and dry cycle. The rack measures approximately 20.669-inch x 20.157-inch.This is a genuine OEM part.

This kit comes with 2 micro switches and a wire harness.

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.

These detergent cup dispenser springs are sold individually.

This genuine dishwasher upper rack assembly provides secure, organized storage for glasses, cups, bowls, and smaller dishes while allowing water and detergent to circulate effectively for thorough cleaning. Designed to slide smoothly on the dishwasher's upper rails, it helps maximize loading space and restore proper rack function when the...Read more original rack becomes rusted, damaged, or difficult to move. This replacement rack is supplied as the rack assembly only; components such as rollers, clips, spray arms, and other attached accessories may need to be transferred from the original rack. Installation typically involves removing the rack stops, sliding the old upper rack out of the rails, transferring any required components, and sliding the new rack into place before reinstalling the rack stops. The rack measures approximately 20 inches wide, 19 inches deep, and 6 inches high.

This part is gray in color and measures approximately 1-1/2 inches wide by 2-1/2 inches high by 1 inch deep. The dishrack roller assembly allows you to roll the rack with ease while the rail supports it. If you notice that the rack is not sliding back and forth easily or the dishwasher is not shutting properly, it may be due to the roller...Read more assembly needing to be replaced. The roller assembly may also break or go missing, and will need to be replaced for these reasons, too. You will need to remove the end cap of the upper rack to remove the entire rack. Use a flat-head screwdriver to snap the old roller assembly out of place. The new rollers just get pushed onto the shaft. Use the clips to lock into place. It is common for these rollers to wear down at the same speed, so you may want to replace all the rollers on the rack at the same time.

This part is used for portable dishwashers.

If your clothes washer is leaking, it is likely that there could be an issue with one of the hoses. If the hoses are in working order, you should check the washers connecting the hose to your unit. Rubber washers are tasked with enhancing the seal between the hose and washer. A faulty or damaged washer will not be able to perform this pro...Read moreperly, and water will be able to leak from the poor connection. This OEM part is sold individually, so make sure you order the quantity that is needed. The washer measures 1 1/16 inches x 5/8 inches.