DLEX7710VE (ASSEEUS) LG Dryer - Parts

This part is sold individually. The drum support roller is found in your dryer. It is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. It is recommended that you replace both rollers at once. You may notice that this part needs to be replaced if you are experiencing a squeaking noise, whi...Read morech could be due to the bearing going bad. The bearing could be severely damaged if you hear a very loud thumping noise, much like you would when you are drying a pair of shoes.

This dryer thermistor temperature sensor helps monitor and regulate the temperature inside a dryer. This part includes the wire harness. If your dryer overheats, does not produce enough heat, or takes too long to dry, then the thermistor might be defective or damaged. This can cause a fault code and could begin either prolonging or shorte...Read morening drying time. As a safety precaution, make sure to unplug the dryer from the power source before beginning this installation, and wear gloves to protect your hands. Refer to the installation instructions provided by the manufacturer for further guidance.

The thermostat is a part for your dryer, and it is roughly 1 inch long by roughly 1.5 inches wide. The purpose of the thermostat is to measure the temperature of the air inside your dryer drum. As the air is being measured, it will turn the heat on or off in order to maintain a stable temperature within the drum. The most common reason yo...Read moreu would need to replace your thermostat is if your dryer is not receiving enough heat, or any heat at all.The tools you will need to complete this repair include a Phillips screwdriver, and a flat-head screwdriver.

This plastic adjustable dryer leg is used to support the weight and adjust the height of your dryer to keep it level. To install the leg, tip the dryer back and screw it into the bottom of your dryer unit. Please note that this dryer leg is sold individually.

This dryer lint filter, also known as a lint trap, is a genuine OEM replacement part made for use with LG dryers. It includes the filter and plastic framing. It fits into a slot on the bottom portion of the door frame. The filter is responsible for capturing and trapping lint and fibers from clothes during drying to prevent them from ente...Read morering and clogging the vent system. This process helps to maintain adequate airflow inside the dryer to reduce the risk of fire and keep the dryer running efficiently.

This silver hinge supports your dryer door on the front panel. These hinges are located on both sides of the dryer door and help it open and close smoothly. Over time, with frequent use, the hinges can wear down, causing them to become less effective at rotating. Additionally, lint or moisture buildup can make the hinges harder to move. P...Read morelease note that this genuine OEM replacement part does not include the necessary screw for installation. You will need to reuse the original screw or order it separately.

This is a lint filter guide cover for models of LG dryers. This guide cover is installed over the lint filter housing within your dryer and ensures that the lint filter is secured during the drying cycle and can be removed afterward. This cover guide measures approximately 15 inches long and 3.75 inches wide and is made of durable plastic...Read more that features two securing holes on either side of it that fasten it within your dryer. To replace this OEM guide cover, you will need a Philips-head screwdriver to remove and install it. This guide cover is sold individually and does not include the necessary securing screws.

This is a rubber bumper made for LG dryers. This bumper is installed on the inside of the dryer door to ensure the metal door does not bend or get damaged when you close it, and ensures a barrier is between the two pieces of metal when the dryer is spinning quickly. To replace this bumper, you will need a Philips-head screwdriver or drill...Read more bit. This bumper is a genuine OEM part and is sold individually, so if your dryer door requires multiple bumpers, consider that before ordering.