My Orders
- Home
- DE6612DXEG
- Instructions
DE6612DXEG Samsung Microwave Oven Combo - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Turntable Quit
5 of 7 people
found this instruction helpful.
-
RICHARD from OKLAHOMA CITY, OK
- Really Easy
- Less than 15 mins
-
Screw drivers
Snipped four corners off inspection panel,removed one phillips screw and two elect. Connections. Reverse process.
Was this helpful?
Thank you for voting!
Thermostat failed because rivet was loose on connector blade; caused overheated wiring.
1 person
found this instruction helpful.
-
Ray from GRANBURY, TX
- Really Easy
- 30 - 60 mins
-
Screw drivers
Replaced the the thermostat located above the magnetron.
Was this helpful?
Thank you for voting!
Power cuts in and out; runs for a few secs then powers off
-
Vinh from Houston, TX
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
Disconnected power and removed Microwave housing cover, observed burned end plastic connector of wire connecting to the thermostat (or thermal overload sensor); slightly wiggle one of the 2 wires to the thermostat would cause microwave power to cut out (when plugged in power). When powered on, I would try to run it but power cuts out aft
... Read more
er just a few seconds. Removed the 2 wires from the old thermostat, removed the 2 screws that fasten down the thermostat, replaced with new thermostat and reapplied the 2 screws; cut off burned part of wire and resolder to new wire connector; reconnect both wires to new thermostat and reinstall MW housing cover. MW works good as new again. Thank you PartSelect!
Read less
Was this helpful?
Thank you for voting!