DE26CS Maytag Dryer - Parts

This is a door latch kit, but you may also know it as a door catch kit. It is designed for your dryer. This part helps hold the door shut on your appliance. This dryer door latch kit comes in two pieces: a door latch, and a door strike or clip. Both parts are a beige white color and made entirely of plastic. Together they are 2 inches wid...Read moree, 1 inch long, and about 1 inch high. To replace the door latch kit, you will need a pair of needle-nose pliers and a number 2 Phillips screwdriver.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This screw is sold individually.

This high-limit thermostat is a critical safety component designed for use in residential clothes dryers. Engineered to prevent overheating, it interrupts power to the heating element when the internal temperature reaches 200°F, and automatically resets once the temperature drops by 30°F, resuming normal operation at approximately 170°F. ...Read moreRated L200-30F, this thermostat features two male 1/4-inch terminals for secure electrical connection. It is compatible with a wide range of dryer models and helps maintain safe and efficient appliance performance. Installation typically involves disconnecting power, accessing the heating assembly, and replacing the thermostat using standard tools. Its compact design allows for seamless integration within the dryer’s internal structure.

This blower wheel clamp, used in a clothes dryer, is a clamp that holds the blower wheel to the motor shaft. This part helps hold the blower wheel in place to function easily and properly. If your clothes dryer has any of the following symptoms then replacing the clamp can be a solution: making loud noises, not producing enough heat or no...Read more heat at all, and/or clothes are taking too long to dry. Make sure to unplug thedryer from power source before installing this part and refer to the installation instructions provided by the manufacturer for further guidance.

This idler shaft retaining ring is well under an inch long and is made of metal.

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This screw is sold individually.

This spring retaining clip is just under 1 inch long. The clip is made entirely of metal and is attached to the back wall of the washer, under the console. If your washer is vibrating and louder than usual during the wash cycle, your spring retaining clip could be faulty or damaged. Check the clip for visible damage, wear, and rust. If yo...Read moreu notice any signs of damage, the part should be replaced. Remember to disconnect the power from your washing machine before starting this repair.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

If your dryer won’t start or the drum isn’t turning, this replacement motor might be the fix. It’s a genuine part made for Whirlpool and related brands like Maytag and Amana. The motor runs at 115 volts and helps spin the drum so your clothes dry properly. This newer version has updated wiring, so you might need to do a little re-wiring t...Read moreo install it. Be sure to check that it fits your model before ordering, and consider having a pro help with installation if you're not familiar with electrical repairs.