DDE7108PML Hotpoint Dryer - Parts

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

This restring coil kit is used to replace the existing coil in a dryer's heating element.

With this high limit/safety thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. This element is meant as a safety device, will kick back in when the temperature drops to 210 degrees Fahrenheit. (Limit: 260-50)

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

This part has three terminals. Note: Use the two smaller terminals for models that only have two wires to the switch.

It has a limit of 145 degrees Fahrenheit and a differential of 15 degrees. This means that with this thermostat, your dryer's heating element will cut out at 145 degrees Fahrenheit and kick back in when the dryer's internal temperature drops by 15 degrees.

This thermostat has a limit of 135 degrees Fahrenheit and a differential of 15 degrees. This means that your dryer's heating element will cut out at 135 degrees Fahrenheit and kick back in when the dryer's internal temperature drops by 15 degrees.

This heating element coil restring kit is intended for use with many of GE's brands of electric clothes dryers. It carries 250 volts, and includes two coils.