DCS7485B DeWALT Table Saw - Parts

This battery cap is designed to protect the terminal contacts on high-capacity cordless tool batteries during storage and transport. Made from durable plastic, it helps prevent debris intrusion and reduces the risk of accidental short circuits when the battery is not in use. Ideal for replacing a lost or damaged cap, it supports safe handling and helps maintain battery condition between uses.

This replacement screw is an authentic manufacturer sourced item. It is commonly used with a variety of power tools. This screw is a standard hardware which has multiple uses based on equipment. To ensure correct location and application of this item please make sure to check appropriate diagrams. It is made out of metal and it is sold in...Read moredividually. Requires a torx or a flat-head screwdriver to tighten/loosen this screw.

This replacement screw is a high quality hardware commonly utilized on Bostitch, Black and Decker, Porter Cable and Dewalt equipment. This is a authentic OEM item which has multiple applications depending on the unit, for correct location and use of this screw make sure to check appropriate diagrams. Please note this torx screw is sold individually.

This replacement hand wheel is sourced directly from original equipment manufacturer. It is a genuine part designed for use with Dewalt table saws. This is the hand wheel that allows you to adjust the blade height. It is made out of metal with a plastic knob. Please note the bevel handle is sold separately. To complete this repair you wo...Read moreuld need a socket wrench. • Remove the handle bolt • Remove old hand wheel • Secure the new assembly with a bolt

This is a genuine OEM approved replacement part made for Dewalt table saws. This wing knob is used to secure the dust cover to the unit. Please refer to diagrams for correct use. It is made out of metal and it is sold individually. Includes a metal washer.

This lock nut is sourced directly from an original manufacturer. It is designed for use with Dewalt table saws. This is standard hardware which has multiple applications based on your tool. Please refer to diagrams for proper application. It is made out of metal and it is sold individually. You would need a wrench to remove or install this nut.

This authentic component is an OEM part which is designed for use with DeWALT table saws. It helps to secure the bevel gear to the shaft. This is an identical replacement for a damaged or a faulty hardware that was installed on a new unit. Keep in mind this high-quality ring is made of durable metal and is sold individually. Make sure to ...Read morecheck the appropriate diagrams of your model for the exact location and the correct installation of this component. It is best to use snap-ring pliers to secure and remove it.

This locating pin is an OEM part from DeWALT. It is used on table saws to prevent the rail from sliding too far. It will require a properly sized wrench to install. The threads may strip or the pin may get lost, so this authentic part will provide an identical replacement of the original pin. Multiple metal pins are used, but this is an i...Read morendividual part priced as one item. Note, a nut is required to secure this pin to the rail which is not included and is sold separately. Please refer to the correct diagram of your specific model to install the pin properly.

This is a genuine manufacturer approved replacement fence knob. It is specially made for use with Dewalt jobsite table saws. This part is made out of black plastic and it is sold individually. Please note, the nut and washer used to secure this knob to the fence are sold separately. You will need a wrench to complete this simple repair.

This is a genuine OEM sourced replacement part designed for use with Dewalt table saws. A push stick is included these saws, attached to the rip fence. Use the push stick to hold the work piece against the table and fence, and push the work piece fully past the blade. This item is made out of plastic and it is sold individually.