DC410KA (Type 1) DeWALT Angle Grinder - Parts

This is an original DeWALT replacement part. The ring is designed by the manufacturer for use in grinders, plate joiners, and sander/polishers. This part is made of metal, and is placed to secure components with the armature and gear housing. You may require a screwdriver and pliers when replacing this item. This product is sold individually.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with DeWALT cordless cut-off tools. The purpose of a brush is to conduct the current in an electric motor by maintaining contact with an armature, unfortunately, over time the material will wear away eventually requiring a replacement to mainta...Read morein peak performance. Keep in mind this high-quality carbon brush with an attached lead wire is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component.

This is a genuine OEM replacement outer nut used on grinders. This part secures the grinding disk to the unit. A spanner wrench (sold separately) is used to tighten and loosen this part. It is made out of metal and it is sold individually.

The lock button goes next to the switch and is made of plastic. This is a genuine replacement part sourced from the original manufacturer for use with chop saws made by DeWALT. This item is priced as an individual replacement. When replacing this part a set of pliers might be required during the installation process. It may become broken and will need to be replaced.

This genuine manufacturer-sourced replacement component which is specially designed for use with Dewalt cordless cutoff tools. It is a complete set which contains the right and the left sides of the housing, please note the hardware that holds the clamshell together is not included, it is sold separately. Keep in mind this set is made of high-quality plastic and is sold individually.

This is an authentic replacement part manufactured for use with DeWalt power tools. The ID Label is a sticker of the DeWalt logo and is often needed when the tools housing is replaced. This logo is sold as an individual replacement part, please see model diagram for associative parts.

This is an original part sourced directly from DeWalt. This grease was designed for use with the equipment listed below and helps to lubricate the system. This extends the life of the tool and protects parts from usual wear by allowing for easy movement. This item is sold individually.

This is an authentic DeWALT and Black & Decker replacement part that is sourced from the original manufacturer for use with saws, grinders, jointers, nibblers, plate joiners, polishers, routers, sanders, and shears. The retaining ring attaches to the ball bearing and is made of metal. When replacing this item an allen wrench and a screwdr...Read moreiver might be required during the installation process. It will need to be replaced if it becomes bent or broken. This part is available as an individual replacement.

This is an original replacement part manufactured for use with electric power tools. The special sleeve is commonly used to provide spacing between the armature bearing and the motor housing. This sleeve is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with shears, joiners, and grinders. The plastic case is used to house and protect the motor assembly and to link the gearcase. This item is available as an individual replacement part and both halves are included. A torx driver is needed to install this item.