DC24B6R Maytag Dishwasher - Parts

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This screw is sold individually.

The faucet adapter for your portable dishwasher or washing machine attaches to the faucet and allows you to connect the machine to the tap. Before you install the faucet adapter on your taps, be sure that it fits the coupler on your dishwasher or washer. As per the factory, this is used for faucets with inside or outside threads. For fema...Read morele connection (outside) just remove the washers. This adapter is approximately 1 inch in length, and slightly less than one inch in diameter. This adapter comes with two different thicknesses of rubber washer. You will not need to use both so be sure to determine which thickness works best for your tap before installing it.

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This inlet hose washer, also known as a high pressure inlet hose washer, is used in washing machines, refrigerators, freezers, and dishwashers. The function of this part is to create a watertight seal in the appliance. If your gasket gets dry and brittle over time it will start to crack and will lose its function. In this case, it is impo...Read morertant to replace it. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance. As a safety precaution, remember to unplug your washer from the power source before beginning.

This screw is sold individually. Size: 8-32 x 1/4 inch.

This authentic OEM coupler gasket creates a watertight seal between your dishwasher hose and the faucet or the water inlet. It ensures leak-free operation and maintains proper water flow during dishwashing. Signs of a broken or worn-out gasket include poor or inconsistent water flow in the dishwasher, resulting in dirty dishes even after ...Read morea cycle. Additionally, a faulty gasket may cause water to drip or spray around the faucet connection or under the sink, potentially leading to water damage. To remove your existing gasket, you will need to locate it within the back panel of the appliance with the help of your user manual. Detach the faucet adapter from the hose by untwisting it. With a flathead screwdriver or pliers, pry the coupler gasket from your appliance. Please note that this replacement part is sold individually.

This screw is sold individually.

Sold Individually. Suggested to replace both at the same time.