D55152 (Type 1) DeWALT Compressor - Parts

This is a genuine OEM approved replacement part designed for use with a variety of air compressors. One quarter turn to fully open/close this drain valve. This part is made out of metal and it is sold individually.

This cold start valve, also referred to as an unloader valve, is supplied by the original manufacturer for use in electric air compressors. It has a length of 0.63 inches, a 1/8-inch male pipe thread, and a hexagonal head for increased stability and security. It allows the compressor to easily start in cold conditions by releasing air pre...Read moressure from the compressor head or the discharge line which reduces the amount of power needed for the motor to start. Once the compressor starts and the pressure in the tank increases, the valve closes and allows pressure to build. If the valve is faulty, the compressor motor will struggle to start, overheat, or trip the circuit breaker. Disconnect the compressor from the power source and open the drain valve to depressurize the tank. Disconnect the pressure switch line from the valve and unscrew the valve using a wrench. Thread the new valve into place and be careful not to overtighten it. Reattach the pressure switch line and close the drain valve to complete the repair.

w/Diaphragm and O-Ring

It is a genuine item that is supplied by the original equipment manufacturer for use with DeWALT compressors. The hose is made out of rubber. A set of pliers and an adjustable wrench might be necessary during the installation of this part. It might break or leak over time and will need replacing. Keep in mind that this item is sold individually.

This replacement gauge is an authentic OEM sourced item designed for Dewalt air compressors. The gauge registers pressure readings and allowing user to maintain the needed pressure. This metal gauge is sold individually. Dial reads 0-200 PSI. You should only need a wrench when replacing this gauge.