D28131 (Type 1) DeWALT Angle Grinder - Parts

The bearing cup is an OEM sourced part that is used with Craftsman angle grinders. This is not an aftermarket imitation part. This item is used to secure the bearing on the commutator side of the armature within the motor housing assembly. This item is available as an individual replacement part.

This replacement screw is a genuine OEM sourced item, it is not an aftermarket imitation. It is specially made for Dewalt grinders. It is generally used to secure the cap and the arm. Please note, one torx screw is included per order.

This genuine manufacturer-approved component is specially made for use with DeWALT and Black and Decker power tools. It is a standard hardware that may have multiple applications, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this nut. Keep in mind this high-quality part is...Read more made of durable metal and is sold individually. Note, you will need a wrench to secure or remove this part.

This replacement item is commonly used on angle grinders and hammer drills. It is sourced from original equipment manufacturer. The purpose of a ball bearing is to reduce friction between two connected rotating parts. Bearings are constantly under heavy pressure. Over time they would wear out and would need to be replaced. This item is sold individually.

This is a Genuine OEM Authorized replacement part used on DeWALT Power Tools. This item is made out of Metal and it is Sold Individually. This is a Standard Hardware Screw which is generally used to hold two pieces of housing together. Requires a Phillips Screwdriver to tighten or loosen this Screw.

This is a genuine Dewalt replacement part, it is sold individually. The 648743-00 acts as brush holder for the models listed below. The 636760-00 Brush Spring is positioned behind this part to keep the brush in contact with the armature. There are two of these parts in the tool.

This is a genuine Dewalt replacement part, it is sold individually. Worn brushes frequently are the cause behind a motor running poorly. • Replacing brushes can fix a motor that’s operating intermittently. • New brushes can restore a motor’s electric braking. Carbon brushes are one of the most commonly replaced power tool parts. T...Read morehis is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This is an authentic replacement part manufactured for DeWalt angle grinders and cut-off tools. The switch fits inside the housing and is actuated by the switch button and link. This switch is used to relay power from the cord to the motor. A decrease in power is likely caused by the power switch wearing out, and a worn switch will cause ...Read morethe tool to have trouble from starting up, or prevent it from starting at all. This switch is sold as an individual replacement part, please note the switch button and link are sold separately.

It is an authentic DeWALT part which is made for small angle grinders. This is the special component which provides a tight fit between connected parts. Unfortunately, over time the hardware may get damaged or lost eventually requiring a replacement to ensure your tool functions properly. One durable metal shim is included. Refer to the a...Read moreppropriate diagrams for your model for the exact location and the correct installation of the new component. You may need a wrench set and pliers to perform this repair.

This genuine OEM sourced replacement part is designed for use with Dewalt grinders. This part helps to direct dust and trimmings away from the user as well as provide protection from the blade while unit is in operation. This part is made out of metal and it is sold individually. No tools are needed to replace this guard.