CTX14EMDRAD Hotpoint Refrigerator - Instructions

Slipped out the old broken cover and slide in the new one. We never thought the cover could be replaced because our refrigerator more than 10 years old. This experience really was an eye opener. Sien

Took old shelf out, put new one in. Not rocket science. Really really simple

Simply removed the old and replaced with the new one.

The key is that I received the part within three days and it was perfect. I have the site bookmarked...but hoping I'll never need to call you. Thanks!

Not really a repair, just replaced the vegetable drawer tray, I just set the part in and it fit perfectly.

It was as easy as removing the broken piece and replacing it with the new one. No tools required.

The repair was very simple, all I had to do is take the old broken one out and replace it with the the New Perfect Fit Part. Thank you for the great customer service ane easy ordering process.

Simply removed all items on lower shelf then removed the old dried up lime that was used to prop the broken pan before. By the way it was placed there about 3 years ago.Anyhow tossed the lime cleaned the area and easily installed the new pan cover , Thank you Part Select .com i definetly will use u all again. Until the next broken part .

Removed all of the stuff on the shelf, then I removed the two vegetable drawers, then I removed the cracked shelf and installed the new.

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

We thought we would have to replace our frig, but found the part online and it fit perfectly. It's slightly different than the original because it is stronger. All we did was remove the items from the tray, unsnap the broken one and slide the new one into place.

Very easy

all I had to do is remove the broken cover then replace the new one which only took about 2 minutes. It was so easy and it is a little more durable than the original one.

Removed the old pan cover, which lifts out very easily, and replaced with the new one. I had to install the two plastic washers, that came with the kit, at the bottom of the refrigerator door around the hinge pin. To avoid having to take the door off to install the washers, I cut a piece out of each washer big enough to fit onto the hinge ... Read more pin. I first lifted the door up and placed a support underneath and then I snapped the washers onto the pin. This was done so the door would close properly. Installation instructions were enclosed with the shippment. Installation was less than 15 mins.

Replaced the cover.

I took out the old cover and slid the new one in place. Unbeievably easy. The old cracked cover was palpably a poorer-quality item than the replacement. The box from PartSelect also included some rubber washers in case the new cover impeded door closing, but it did not. Thank you very much, PartSelect!