CSWE1 Scotsman-Residential Ice Maker - Parts

Metallic screw that is less than an inch long. Does not include the plastic washer.

There is approximately 10' of wire. Note: 2 kits are needed to replace both directions.

Used on freestanding ice makers.

Also known as evaporator control thermostat - used for stand-alone ice makers.

This is a terminal cover for the compressor in a refrigerator. This covers the relay and overload switch on the compressor. Once you have gained access to the terminal cover, you will see that the cover is held on by a tension or retaining clip. Simply pop the cover off and replace with the new cover. The cover is made of plastic and is b...Read morelack in color. It measure less than 3 inches long and less than 3 inches wide. This is a genuine replacement part from the original manufacturer.

This filter dryer is for refrigerators and filters refrigerant that travels through the sealed system of the refrigerator.

Used in stand-alone ice makers. The cycling thermostat controls the activation of the icemaker ejection cycle.

This single outlet water valve is intended for use with some commercial ice machines, and not refrigerator icemakers. It comes with a mounting bracket, two screws, and a washer.