CS2147EPA (2004-03) Jonsered Chainsaw - Parts

This is an authentic replacement part that is sourced from the original manufacturer to be used with chainsaws. The special valve is threaded and screws into the cylinder. The valve is used to allow air to escape the combustion chamber to make it easier to turn the engine over when pulling the recoil starter rope. The valve is opened prio...Read morer to starting the engine and combustion within the cylinder causes the valve to close once the motor is started. A hex socket wrench is required to install this item and the valve is sold individually.

This Air Filter is an authentic OEM part and is used in Husqvarna Chainsaws. Replacing the filter often will keep dust, dirt and other air contaminants from entering your engine thus further avoiding smaller engine repairs. The filters inside are made of a nylon mesh and the outside is made of a hard plastic. This part attaches with a spr...Read moreing that is attached to the carburetor manifold. This air filter is an individually sold part.

This is an OEM part sourced directly from the manufacturer. The oil pump assembly is designed for use in Husqvarna chainsaws. This part is made of metal, and is used to lubricate the bar to prevent the chain from overheating. You may require a screwdriver and wrench when replacing this part. This item is sold individually.

This is an authentic OEM sourced replacement piston ring which is designed for use with Husqvarna chainsaws and brushcutters. The ring helps to create and air-tight seal between the piston and the cylinder walls, a worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase, causing low compression an...Read mored a loss of power. If compression is reduced significantly, the engine will not run at all. Please note this part is made of high-quality metal and is sold individually.

This intake manifold bellows (intake boot) is a genuine OEM Husqvarna replacement designed to connect the carburetor to the engine cylinder and seal the intake system. Made from durable rubber, it helps maintain the correct air-fuel mixture and prevent air leaks, making it an ideal replacement when a cracked or hardened boot causes poor running, rough idle, or starting issues.