CS2145EPA (2004-03) Jonsered Chainsaw - Parts

This is a genuine Husqvarna replacement part. The heat deflector is designed by the manufacturer for use in chainsaws. This part is made of metal, and is placed to block the heat from the cylinder to protect the carburetor. You may require an Allen wrench or screwdriver when replacing this item. This product is sold individually.

This is an authentic replacement part that is sourced from the original manufacturer to be used with chainsaws. The special valve is threaded and screws into the cylinder. The valve is used to allow air to escape the combustion chamber to make it easier to turn the engine over when pulling the recoil starter rope. The valve is opened prio...Read morer to starting the engine and combustion within the cylinder causes the valve to close once the motor is started. A hex socket wrench is required to install this item and the valve is sold individually.

This is an OEM part sourced directly from the manufacturer. The oil pump assembly is designed for use in Husqvarna chainsaws. This part is made of metal, and is used to lubricate the bar to prevent the chain from overheating. You may require a screwdriver and wrench when replacing this part. This item is sold individually.

This is an authentic OEM sourced replacement piston ring which is designed for use with Husqvarna chainsaws and brushcutters. The ring helps to create and air-tight seal between the piston and the cylinder walls, a worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase, causing low compression an...Read mored a loss of power. If compression is reduced significantly, the engine will not run at all. Please note this part is made of high-quality metal and is sold individually.

This intake manifold bellows (intake boot) is a genuine OEM Husqvarna replacement designed to connect the carburetor to the engine cylinder and seal the intake system. Made from durable rubber, it helps maintain the correct air-fuel mixture and prevent air leaks, making it an ideal replacement when a cracked or hardened boot causes poor running, rough idle, or starting issues.

This is a genuine item that is supplied by the original equipment manufacturer for Husqvarna chainsaws. It is an identical replacement for a missing or damaged pinion that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality part is made of durable material and is sold individually.

This genuine component is supplied by the original equipment manufacturer for use with Husqvarna and Poulan chainsaws. It provides an identical replacement for a missing or a faulty starter catch spring that was installed on a new unit. The spring helps to apply tension in the recoil starter assembly. Please make sure to check the appropr...Read moreiate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality spring is made of durable metal and is sold individually.