CS2138C (2006-01) Jonsered Chainsaw - Parts

The trigger kit goes next to the handle cover and the rear handle. This is available as a kit that contains all the necessary parts. A screwdriver may be helpful when replacing these items. These parts are made out of metal and plastic and will need to be replaced if they break. They are Poulan and Jonsered replacement parts directly sourced from the manufacturer for use in chainsaws.

The flywheel nut fits between the flywheel and the starter pulley. It is made of metal and is sold individually. This is a genuine OEM sourced part which is specially designed for use with Poulan, Husqvarna, and Jonsered chainsaws. During the installation process, a wrench will be needed to replace this part. Over time this nut may break or become stripped and will need to be replaced.

This is a genuine item that is supplied by the original equipment manufacturer for use with Poulan and Jonsered chainsaws. It is an identical replacement for a damaged or a faulty oil pick up assembly that was installed on a new unit. The part carries oil from the tank to the oil pump. To ensure the exact location and the correct applicat...Read moreion of this component, refer to the appropriate diagrams for your model. Note, this high-quality part is sold individually. A screwdriver and pliers might be needed to perform this repair.

This is an original part from Poulan and Jonsered for use with Chainsaws. The start/stop switch lever spring starts or stops the chainsaw when engaged by the switch lever. The most common reasons for replacing the start/stop switch lever is if the engine won't start, ignition lever is broken or damaged, lever not engaging ignition contact...Read mores, engine dies suddenly (and/or intermittently), or the kill-switch is not engaging. This part is sold individually. The tools that you will need to replace the start/stop switch lever is a phillip's driver, torx drivers, flat-head screwdriver and a ratchet/socket set.

This part is sold individually. The cylinder shield is made out of plastic. A screwdriver may be required to replace this part. It will require replacing if it breaks. This part is an OEM sourced directly from the manufacturer for use in Poulan saws.

This is an OEM replacement part for Craftsman chainsaws. The module kit produces the voltage that travels down the spark plug wire to the spark plug, then to the engine. This part is made of metal and plastic it is also sold individually. For installation, you will need a screwdriver, a socket wrench and a pair of pliers to aid you. Before starting this repair be sure to let the engine cool completely.

This is a genuine Poulan, Husqvarna, and Jonsered replacement part used in compatible chainsaws. The hub fits between the screw and the spring and helps to start the engine. You may need a screwdriver, a socket set, and torx bits when replacing this part. It may become broken and will need to be replaced. This part is available as an individual replacement part and is made of plastic.

The right cylinder insert attaches to the cylinder. It is an OEM from Poulan for use in saws. Keep in mind this part is made of plastic and is sold individually. If this part becomes broken it will need to be replaced and may require a set of pliers during the installation.

Insert transfer por

Assembly-oil vent

This handguard is a genuine Poulan part that has been OEM sourced to ensure quality. This item is intended to be used with chainsaws. The handguard connects to the chassis in front of the forward handle. The handguard is used to actuate the chainbrake to stop the chain rotation and to protect the user. This item is priced as a single item.

This is an authentic Poulan replacement part manufactured for use with chainsaws. The choke knob is used to actuate the choke lever to open the choke when starting the engine. This choke knob is available as an individual replacement part, please see model diagram for associative parts.