CLZ8502ADB Magic Chef Cooktop - Instructions

I replaced the broken grommets with the new ones. I purchased 8 so I would have back ups because I did not feel the new one would last either. I think they cost TOO MUCH but I could not haggle for price.

very easy to push each grommet into range top holes

saw burner tube was completely rusted at end and would not line up with burner. decided to go ahead and replace all three tubes. was easy to install, able to get a good cleaning job on unit in the process. works fine, wife is happy and that is what matters in a motorhome.

pull knob off streight out. remove two phillips head screws, disconnect wire to disassemble. To reassemble reattatch wire to replacement igniter, screw in two phillips head screws and push on the knob.

Pushed into hole by hand, really simple

Pulled knob,removed 2 screws removed wire,removed old ignitor repl. With new reversed procedure,done

This item had to be returned. Didn"t fit. Our shaft is shorter, and the new knob would not stay on.

easy replaced after giving proper model and serial numbers. They were very helpful sending pictures so i could choose which knob might work as they had two for the same model number. The person answering my call was very helpful. Also return of the wrong ones I ordered was easy and refund prompt. I would highly recommend this company. ... Read more Gail from Mo.

The igniter on our RV stove top failed after 4 years of operation. The repair took about 8 minutes and everything works fine.

So simple would be embarrassed to give any instructions; it is so self evident.

The old knob simply slides off the shaft. I aligned the fins on the back of the new knob with the grooves on the shaft of the ignitor and pressed the new knob on.

put in new flashtube

Just pushed the new grommet into the hole. The grommet fit just fine and took about 10 seconds to install.

I ordered the grommet... Didn't match the others ... But it fit on , and will do the job

Put new parts on & the only trouble I had , I had no ideal where the or how the Extension flash tubes went on had to take one of the burners off & looked it over & found out it had two little what I`ll call slices in it to put the tubes on after that it all went in place very easyly it all worked just fine