CH20S-64708 Kohler Engine - Parts

This is an original Kohler replacement part manufactured for use with small engines. The carburetor gasket forms a seal between the carburetor and the cylinder. It is recommended to replace the gasket when servicing the carburetor to ensure a good seal when the parts are reinstalled. This gasket is available separately.

This is an authentic OEM part. The intake valve (std.) is constructed of high-quality metal, and is used in many small lawn and garden engines. This component is secured in the cylinder head assembly, allowing the specific fuel mixture to go through the engine. The intake valve is sold individually, and an adjustable wrench is necessary for the proper installation.

This is a genuine OEM authorized replacement part that is specially produced for use with Kohler engines. It is made from high quality composite material and it is sold individually. This gasket acts as a seal for the air cleaner base. Over time gaskets tend to wear out and crack eventually requiring replacement.

Hose clamp. This clamp replaces 25 237 14-S

Washer, flat 8.6 mm

This air cleaner/filter cover kit is supplied by the original manufacturer for use in lawn mowers. It includes one plastic cover, and the necessary mounting hardware - one knob, one seal and two metal brackets. The cover prevents moisture and debris from entering the air cleaner housing and damaging the air cleaner. The air cleaner cover ...Read morewill need to be replaced if it becomes cracked, damaged, or loose, to prevent contaminants from entering the engine. A faulty air cleaner cover will result in low power output, increased fuel consumption, engine stalling, and engine damage if left unaddressed. Remove the fasteners that secure the cleaner cover and pull it off the equipment. Clean the air filter housing and replace the air filter if necessary. It is recommended to inspect and replace the air filter every 3 to 6 months for optimal engine performance. Align the new cover with the mounting holes and secure it in place using the appropriate fasteners.

This is a genuine OEM sourced part used on many small engines. The Kohler reed retainer is constructed of metal, and is designed to hold the breather reed. The reed retainer is sold individually. A wrench is necessary for the proper installation.

Sourced directly from the manufacturer, this 6mm Flat Washer is made of durable dark grey metal, is not part of a kit or assembly, and is sold individually. This part should be replaced when it is damaged, worn, or can no longer spread the load under a bolt sufficiently. This Washer is found in various locations, depending on your model. Customers rate this repair as Easy.

This is an authentic OEM component from Kohler. The oil cooler o-ring is made for use with many small engines, and is sold individually. The plastic o-ring is fitted inside the oil cooler, providing a protective seal. An Allen wrench and pliers are often required for the proper installation.

This is an authentic OEM part for engines made by Kohler and Toro. The inner air cleaner seal attaches to the ring retainer and the fuel spitback cup. A wrench might be needed during the installation process. It will need to be replaced if it becomes broken. This part is available as an individual replacement and is made of rubber.