CFGF3023LWD Frigidaire Range - Parts

Sold individually.

This oven bottom panel is a genuine OEM replacement designed to protect the bake element in gas ranges from spills, drips, and debris. Positioned above the bake burner, it acts as a barrier that helps prevent damage while promoting even heat distribution throughout the oven cavity. Crafted to manufacturer specifications, the panel support...Read mores consistent cooking performance and extends the life of internal components. It is ideal for replacing warped, stained, or damaged panels that may affect heat flow or cleanliness. Installation is straightforward and typically involves sliding the panel into place above the burner. Always verify your appliance’s model number to ensure compatibility.

This valve automatically cuts off the flow of gas at a certain pressure.

The function of the ignitor in your range is to create the spark that ignites the gas on the burners. If your spark ignition system is not functioning properly, you may need to replace the ignitor. This part is approximately 3 inches in length. The ignitor is located in the rear of the range, so you will need to remove the back panel in o...Read morerder to access it for this repair. Before beginning this repair, be sure that the gas valve for the range is shut off. You should also disconnect the power source to the range before you begin.

A light or fan that responds only when its control is moved may have a worn rocker switch. This replacement switch mounts in the appliance panel and controls power to the assigned feature. Its exact job varies by model, so check the wiring diagram before installation. First inspect the bulb or fan, wiring, terminals, and power supply beca...Read moreuse another fault may be responsible. Turn off the circuit breaker and confirm the appliance has no power. Allow the cooking area to cool and wear gloves around sharp panel edges. Label each wire, avoid pulling on the wire itself, and make sure every terminal fits tightly during reassembly.

This is a replacement burner knob for your range. It is made of plastic and is white in color. It measures approximately 2 inches in diameter. The knob allows you to turn on and adjust the heat level of the range. If the knob is stripped so badly that the shaft will not turn when you turn the knob, or if the knob is damaged, it will need...Read more to be replaced. To replace the knob, carefully remove it from the shaft and replace it with a new knob. This part is sold individually and is a genuine OEM part from the manufacturer. This part has been updated by the manufacturer. Please check model compatibility before ordering.

This igniter has a short wire harness. The wire length is approximately 6 inches long.

Four switches are included with the assembly.

Sold individually.