CFEF366EMF Frigidaire Range - Parts

This surface burner knob is used in ranges and ovens. The knob allows you to control the temperature on the surface burner located on the range. It has a D-shaped shaft and the measurements are: 4 inches in length, 5 inches in width, 1 inch in height, and it weighs 0.01 pounds. It comes in a black color with a white pointer. If your knob ...Read moreis broken, will not turn on or off, or it does not rotate, replacing this part can be the solution to your problem. Remember to unplug your range from the power source before beginning this project. Refer to the manual provided by the manufacturer for further installation instructions.

This part is sold individually. The leveling leg is black in color and measures approximately 2 inches in length. It is made of plastic. The leveling leg is found underneath your range and may crack or wear down over time. This will need to be replaced if it has broken or gone missing. If you notice your oven is wobbling or uneven it may ...Read morebe due to the leveling leg needing to be replaced. This part can be adjusted to accommodate different heights due to uneven flooring. This is a genuine OEM part sourced directly from the manufacturer.

This is the overly only. Control board is NOT included. Black in color. Genuine OEM part.

This door trim kit provides a clean, finished look for your oven door while protecting the edges from wear. Designed as a three-sided frame for the sides and bottom, it enhances both the appearance and durability of the appliance. Replacing damaged or worn trim helps restore the oven’s overall look and ensures a secure, polished finish.

This oven door gasket creates a secure seal around the door to keep heat inside the oven for consistent cooking and energy efficiency. Made from high-quality, heat-resistant fiberglass with a tempered wire insert, it offers superior durability compared to standard seals. The gasket measures approximately 80 to 84 inches in length and incl...Read moreudes 16 mounting clips for easy installation—simply remove the old seal and press the new one into place. Replacing a worn gasket helps prevent heat loss, uneven cooking, and extended preheating times.

Sold individually.

This oven door light switch signals the light to turn off when the oven door closes. If your light switch is defective or you smell a burning odor, make sure to check the switch and replace it. The tool needed for this replacement is a screwdriver. Locate the switch, usually from under the oven top. Remove the wires and pull the switch ou...Read moret. Refer to the diagram provided by the manufacturer for further instructions and guidance before installation. Make sure you remember to unplug the oven from the power source before starting this repair, and wear gloves for protection.

Sold individually.